Assembly Instructions For
Comfort-Bilt Pellet Stove Universal Control Board (16-Pin Connector): CB-RIBBON CONNECTOR-CONTROL-BOARD
Board Install Instructions:
1.) Unplug the power from the stove.
2.) Apply gentle pressure to the board in an upward direction (This should allow the board to separate from the mounting bracket).
3.) Unplug the connector from the back of the board.
4.) Plug the connector into the new board.
5.) Position the board over the mounting screws and slide the board into place.
6.) Plug in the stove and follow the setup instructions.
Board Set-Up Instructions:
-Power cycle the unit using the main power switch at the rear.
-As soon as the panel powers up, it will give an audible beep and display the model it is programmed for.
-As soon as you hear the beep, press and hold the right arrow button (return).
-The screen will now change to display a cursor arrow to the left (You can scroll up and down to make changes to the Mode, Voltage, and Frequency).
-For US customers, you want to make sure that the Mode is set to the correct model ending in _U01, the Voltage is set to 115V, and the Frequency is set to 60Hz. See below the models and their compatible modes.
- HP50S_U01 for HP50S
- HP21_U01 for HP21
- HP60S_U01 for HP22 and HP22I
- HP60N_U01 for HP22N
- HP61_U01 for HP61
-Press the left arrow button (Enter) to highlight the selection.
-Once highlighted, press Up and Down to change to the desired mode.
-Then press Enter to lock in the selection. Once locked in, you can back out using the Return key.
-Power cycle the unit and watch the boot sequence to ensure that the selection took.
-It should display the Mode/Voltage/Frequency that was selected previously.
Click here for additional information on how to program your board!