Napoleon Oakdale EPI3 Secondary Air Tube Cotter Pin: W485-0047

Replacement For Part Number:

• W485-0047

These are all of the confirmed compatible units for this product. This product may fit others, but these are the only ones we suggest ordering it for at this time.

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Napoleon Oakdale EPI3 Secondary Air Tube Cotter Pin: W485-0047

Instructional Notes

This is a basic overview of how to replace the auger/drive motor. This process will vary depending on the unit!

1.) Make sure that your unit is cool to the touch.

2.) Unplug the stove.

3.) Remove the needed panels to gain access to the auger/drive motor.

4.) After locating the motor, disconnect the wire leads connecting the motor to the wiring harness.

5.) Using a pair of pliers, remove the retainer pin that attaches the auger motor to the auger shaft (This should release the auger motor). On some motors, a set screw will need to be removed.

6.) Position the new auger motor in place (You may need to rotate the auger to line up the hole on the auger shaft with the hole on the stub of the motor).

7.) Install the previously removed retainer pin or set screw.

8.) Reconnect the wire leads to the wiring harness.

9.) Reinstall any previously removed panels.

10.) Plug in the unit and test the motor.

This Item Qualifies For Free Shipping With Orders Over $99!