Install Instructions For US Stove Fresh Air Intake Kit (Pellet/Multi-Fuel) Stoves: 69FAK
Instructional Documents:
1.) With the stove in the operating position, mark and drill a hole to accommodate the 2" flexible hose.
2.) Insert the hose through the wall and attach the Outside Cover with one of the 2" hose clamps provided. See Figure 1.
3.) Then attach the Outside Cover to the outside wall.
4.) Next, attach the Rodent Cover to the Outside Cover using four(4) of the #10 x 3/4 screws supplied.
5.) On the inside of the home, slide the Inside Plate over the tube, then attach to the wall with the four Drywall Anchors and screws provided. See Figure 2 (For the Insert model, skip to step 8).
6.) On the Air Inlet Tube coming out of the firebox, there is a cap that must have four(4), 5/32"(0.156) diameter holes drilled in it for the fresh air installation. The cap is on the front side of the tube just under the burn pot. Remove the burn pot. Using a long screwdriver or equivalent, knock the cap off by inserting it from the back of the stove and pecking with a hammer. Drill holes, then replace the cap and burn pot.
7.) Attach one of the 2" flex hoses to the backside of the firebox, then to the air inlet pipe at the back of the stove as shown in Figure 3.
8.) Stretch the 2" flex hose to the air inlet on the back of the stove. Attach using the other 2" hose clamp. See Figure 3. (The hose will extend up to 4 feet in length.) For the insert model, only one flex hose will be used.
