Cuisinart Pellet Grill 10.5" Auger Shaft & Motor Repair Kit

Is your Cuisinart pellet grill not feeding pellets or getting jammed? Several parts could cause that! Get all the necessary parts in one kit. Replacing all these parts will improve the grill's efficiency, maintain steady temperatures and smoke insulation within the grill barrel, as well as help you save more money if you purchase them as a kit rather than buying them separately. The overall auger shaft length is 10.5″. Compatible with Cuisinart CPG-465 Pellet Grills.

Included In This Kit:

• 1 x Auger Shaft (SUB023)
• 1 x Auger Bushing (0036-602-0036-0)
  
• 1 x Auger Motor (0036-601-0036-3)
• 1 x Hopper Burner Gasket (INS144)
  
• 1 x Auger Shaft Nut and Bolt (0036-602-0036-1)

This kit uses aftermarket parts where applicable to help you save big!

 

 

 

 

View Compatible Models

UPC: 634868919022

Install Instructions For Cuisinart Pellet Grill 10.5" Auger Shaft & Motor Repair Kit

1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord.

2) CAUTION! If the Grill is still hot, allow it to thoroughly cool.

3) Remove any covers necessary to access the Auger Drive Motor.

4) Remove the screw connecting the Auger Drive Motor shaft to the Auger shaft and the screw retaining the Auger Bushing into the Auger Tube.

5) With a small pipe wrench or locking pliers on the Auger shaft, turn the Auger counterclockwise. It will turn hard until it breaks free, then the Auger will turn freely.

6) Remove the Auger and clean all Pellets, ash or foreign objects from the Auger, Auger Tube, and Firepot. (See instructions for proper handling and disposal of ash in Section Five)

7) Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the Auger Tube and sand it if needed. Vacuum the sanding grit out of the Auger Tube and Firepot when finished. Check that the Auger rotates freely.

8) Re-attach the Auger shaft to the Auger Drive Motor shaft.

Auger shafts can often bind up inside the feed tube if they become warped. This can happen if the pellets in the feed tube become wet. To verify if you warped, remove the shaft and roll it across a flat surface. If it is warped, you will notice the slight bend as it rolls.

Unfortunately, sometimes products do not work like they are supposed to. We offer a 90 day warranty on manufacturer defects. Some manufacturers make this a very simple and easy process unfortunately others do not. Items must be used in accordance with the manufacturers guidelines to qualify for warranty replacement. Please be advised that warranty claims for these parts may take up to 4 weeks for processing, and customers must cover shipping.

This Item Qualifies For Free Shipping!

Learn More About Our Shipping Information