Ashley Exhaust Blower Motor Housing (Housing Only): A-E-027J-BH

Ashley Pellet Stove Exhaust Blower Housing (Does not include blower).  The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air into the stove.  It is important that the blower functions properly.  If the blower is not running as it should, smoke/flue gas may enter the room.  You may also notice a lazy flame and a poor burn as a result of inadequate combustion air being delivered to the fire.   

UPC: 012685000985

Replacement For Part Numbers:

• A-E-027
• 80641
• A-E-027J

These are all of the confirmed compatible units for this product. This product may fit others, but these are the only ones we suggest ordering it for at this time.

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

This product is a kit containing 3 total items.

Component Technical Specs

Open a part to see its specifications.

1 xCombustion Fan Gasket Odd Shape

SKU 88100 (ASH) (opens in new tab)

Quantity In Kit	1
Length (in)	8 ½"
Width (in)	6 ½"
Height (in)	.1"
Inner Diameter (in)	4 ⅞"
Thickness (in)	0.188"
Weight	.25 oz

1 xGasket combustion motor to housing 6" round generic fits most stoves - 1

SKU C-G-105 (ASH) (opens in new tab)

Quantity In Kit	1
Length (in)	6"
Width (in)	6"
Height (in)	.1"
Outer Diameter (in)	6"
Inner Diameter (in)	4.88"
Thickness (in)	0.12"
Inner Dimension	4 3/8''
Outer Dimension	5 7/8''
Weight	0.25 oz

1 xCombustion Blower 1/4" Slotted-Hex Piercing Screws (Set of 6)

SKU HDW500 (opens in new tab)

Quantity In Kit	1
Weight	0.25 oz

Install Instructions For Ashley Exhaust Blower Motor Housing (Housing Only): A-E-027J-BH

Instructional Documents

• Install Instructions PDF for Ashley A-E-027

Instructional Notes

To replace the exhaust blower:

1. Unplug the unit
2. Open the service panel
3. Locate the exhaust blower. If your unit has the original OEM blower, you may have to remove the entire blower assembly if the motor cannot be removed from the hub. This will also involve removing the vent from the end of the assembly. If you have a Breckwell Insert, you will need to remove the entire off-set assembly from the of blower assembly and attach it to the new assembly if you have a hub-less motor.
4. Disconnect wiring
5. Replace blower assembly along with any gaskets that were disturbed (included).
6. Reconnect venting if it was disconnected
7. Reattach the wiring
8. NOTE: if the venting was removed, make sure to apply RTV silicone to the venting adapter and secure with a single self tapping screw.

This Item Qualifies For Free Shipping With Orders Over $99!