Assembly Instructions For
ComfortBilt Pellet Stove Auger Motor: CB-AUGER-MOTOR
1.) Disconnect the power from the stove.
2.) Remove the side and rear panels from the unit (You may only need to remove 2 panels).
3.) Disconnect the auger motor power wire from the harness.
3.) Loosen the set screw that holds the auger motor to the auger shaft.
4.) Locate and remove the 4 outer bolts that hold the auger motor and U-bracket to the underside of the hopper.
5.) Separate the U-bracket from the old auger by removing the 4 Allen bolts (This bracket will be reused).
6.) Attach the new auger motor to the U-bracket using the 4 previously removed Allen bolts.
7.) Reinstall the auger and U-bracket to the bottom plate (Make sure that the flat side of the auger motor post lines up with the set screw).
8.) Tighten the set screw to the auger shaft.
9.) Plug the auger motor power wire into the harness.
10.) Reinstall the side and rear panel & plug in the stove.
Click on the Videos tab above or See ComfortBilts Guide to Auger Testing for more information!