ComfortBilt HP22 Pellet Stove Repair and Replacement Parts

ComfortBilt Pellet Stove Replacement Igniter.  The Igniter / Hot Rod works by super heating the air that passes through the burn pot.  This super-h...

ComfortBilt Cast Pellet Stove Burn Pot.  When installing the burn pot make sure the ignitor port hole is towards the back of the stove.  It is also...

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

ComfortBilt Pellet Stove Main Power Switch.  This switch is located on the rear of the unit.  The purpose of this switch is to provide power to all...

Replacement Lower Auger Bearing for ComfortBilt Pellet Stoves.  The bottom bearing is located underneath the circular plate and is held in place by...

Replacement Upper Auger Bearing for ComfortBilt Pellet Stoves. When reassembling, ensure that the bearings are in place and do not bind up when the...

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

ComfortBilt 250V-10A Backup / Main Power Switch Fuse.  This fuse is located in the Main Power Switch on the back of the stove.  In the switch there...

ComfortBilt Pellet Stove Replacement Igniter.  The Igniter / Hot Rod works by super heating the air that passes through the burn pot.  This super-h...

Replacement Door Gasket for Comfort Bilt Pellet Stoves.  

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

ComfortBilt Pellet Stove Exhaust Gasket (6.5" DIA. W/ 5/8" centered hole).  The exhaust gasket creates an airtight seal between the fans mounting p...