Pleasant Hearth Round Exhaust Blower Motor Hub Gasket (6"): 812-4710

6" AMP Stove Exhaust Motor Gasket

• Motor side 4 7/8" ID 6" OD
• For use between blower housing and exhaust motor.

***note this will fit stove models that have the 5 3/4" quick change style hub only***

We carry a huge selection of pellet stove parts at super low prices. We have some of the best support staff to answer all your questions before you order.

UPC: 652174168279

Replacement For Part Number:

• 812-4710

These are all of the confirmed compatible units for this product. This product may fit others, but these are the only ones we suggest ordering it for at this time.

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Pleasant Hearth Round Exhaust Blower Motor Hub Gasket (6"): 812-4710

Instructional Documents

• Install Instructions PDF for Pleasant Hearth 812-4710

Instructional Notes

1.) Unplug your stove and make sure the unit is cool to the touch.

2.) Locate the combustion blower (directly behind the exhaust collar on most stoves). To gain access to this area you may need to remove the rear and side panels (This will vary depending on what stove you have. In some cases, the exhaust vent will need to be disconnected).

3.) Loosen and remove the bolts attaching the combustion blower to the combustion blower housing.

4.) Remove the blower from the blower housing and set it next to the unit. Take care not to damage any wires.

5.) Remove the old gasket. If sections of the old gasket are stuck to the housing, you can use a flathead screwdriver to remove them.

6.) Once the surface is clean position the new gasket in place. On most units, the combustion blower can be attached to the unit once the screws are partially threaded into the blower housing. If this is the case with your blower, you should get the screws started while your positioning the gasket in place.

7.) If your gasket is set in place and the screws are partially threaded into the blower housing, line up the holes on the blower flange with the screws on the housing, set the blower in place, rotate the blower slightly and tighten the screws down in a crisscross pattern.

8.) Reinstall any previously removed panels/vent pipe and plug in your stove

Troubleshooting Notes

If you smell or see smoke when operating your unit, the unit should be shut down and all gaskets should be inspected.

The combustion blower gasket should be inspected on a regular basis. When inspecting around the combustion blower look for signs of smoke spillage. Often you will see black or brown stains on or around the combustion blower gasket if there is a leak in this area. You can try tightening the screws if they are loose. If tightening the screws does not resolve the issue or the gasket is visibly damaged it should be replaced!

This Item Qualifies For Free Shipping With Orders Over $99!