Ashley (Wood/Pellet) Stove Fresh Air Intake Kit: 4FAK

Ashley (Wood/Pellet) Stove Fresh Air Intake Kit: 4FAK.  The outside air kit allows the unit to draw combustion air from the exterior.  This can help resolve burn issues caused by inadequate combustion air.  An outside air kit may be required to meet specific clearance or code requirements.  

Replacement For Part Number:

• 4FAK

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Ashley (Wood/Pellet) Stove Fresh Air Intake Kit: 4FAK

Instructional Documents

• Install Instructions PDF for Ashley 4FAK

Instructional Notes

1. With the stove in the operating position, mark and drill a 5” hole through the wall at the desired point of entry. The point of entry should be at or below the level of the intake air tube on the stove.

2. Slide the tail portion of the weather hood through the hole. Secure the weather hood with the provided screws at each of the four corners. Caulk around the edges of the hood and screws to seal. This task should be done after the stove has been installed and the exhaust piping routed. Try to position the hole for the air intake as close to the stove as possible.

3. Slide both hose clamps over the aluminium flex pipe. Then slide the flex pipe over the air intake tube of the stove. Next tighten the hose clamp over the end of the aluminium flex hose.

4. Secure the FAK cover to the wall using the provided hardware. Route the flex pipe through the through-wall connection and slide the flex pipe over the tail piece. Apply the second hose clamp over the tail piece and tighten.

This Item Qualifies For Free Shipping!