Ashley (Wood/Coal) Furnace Distribution Blower. The distribution blower is responsible for circulating room air around the furnace and into yourductwork. If the blower is not working as it should, the amount of heat transferred from the furnace into your home may be reduced. If the fan has been cleaned thoroughly and is not moving the same volume of air as it once did it may need to be replaced.
Install Instructions For Ashley Furnace Distribution Blower: 80594-AMP
1.) Disconnect the power from the unit.
2.) Remove the two screws holding the wire cover to the blower housing.
3.) Remove the wire cover.
4.) Untwist and remove the wire nuts from the wires coming from the blower to the conduit.
5.) Loosen and remove the lock nut holding the conduit to the wire housing (The conduit is now free from the blower).
6.) Next loosen the 4 bolts holding the blower to the furnace.
7.) You can now remove the blower from the unit (Check the gasket at this time. If it is damaged or worn it will need to be replaced).
8.) To install the new blower thread one bolt through the blower and gasket (This will help you position the gasket in place).
9.) Next insert and tighten all four bolts to the rear of the furnace.
10.) Remove the wire cover from the newly installed blower.
11.) Using a flathead screwdriver remove the knockout from the side of the blower housing.
12.) Pull out the wires from the blower wire housing and strip approximately a 1/4" of the plastic off of the ends of the wire.
13.) Insert the wires from the conduit through the knockout and position the conduit in place on the side of the wire housing.
14.) Replace the lock nut on the inside of the wire housing and tighten the nut to secure the conduit to the housing.
15.) Connect the black wire from the blower to the black wire from the conduit and the white wire from the conduit to the white wire from the blower.
16.) Reinstall the wire nuts.
17.) Reposition the cover and tighten the two screws.
18.) Plug in your unit and test the blower.
Troubleshooting
-If your distribution blower does not seem to be moving the same amount of air as it once did inspect and clean the blower. Distribution blowers will often draw dust and pet hair into the blades of the fan when operating. If the fan blades become packed with dust, hair, or other debris this can greatly reduce the efficiency of the blower. Often, a thorough cleaning will resolve this issue. If the blower continues to rotate at a slower speed after it has been cleaned or you hear excessive noise coming from the fan it may need to be replaced!
Warranty
Unfortunately, sometimes products do not work like they are supposed to. We offer a 90 day warranty on manufacturer defects. Some manufacturers
make this a very simple and easy process unfortunately others do not. Items must be used in accordance with the manufacturers guidelines to qualify for warranty replacement. Please
be advised that warranty claims for these parts may take up to 4 weeks for processing, and customers must cover shipping.
Shipping Information
This Item Qualifies For Free Shipping!
When Will My Order Ship?
All orders are typically processed within 24 hours of receiving payment and are shipped from us same day if placed before our shipping cutoff time (Monday - Friday: 12PM, Saturday: 10AM, Sunday: No Shipping), orders placed after our cutoff time are shipped the next morning.
Do You Offer Express Shipping?
Yes! Please note the shipping times are based on business days, weekends and holidays do not count to the delivery date. Please see our expedited ship time schedules here.
How Does Free Shipping Work?
Most orders over $99 qualify for free shipping! Orders which ship for free are shipped with either USPS or UPS based on our discretion. If you are using a PO box, free shipping orders will always go USPS.
Do You Ship To Canada?
We ship to Canada! We estimate USPS to take 4-10 days once receiving your package from us. We do not offer expedited shipping of any kind to Canada. Please allow an extra 2-5 days for all shipments to Canada. Free shipping is not available to Canada.
Do You Ship To Alaska Or Hawaii?
We ship to both Alaska and Hawaii! We do not offer next day or two day shipping to Alaska or Hawaii. Free shipping is not available to Alaska or Hawaii.
Do You Ship Outside The US Or Canada?
Unfortunately, at this time we do not offer international shipping other than to Canada.
Shipping Time Estimations
For information on shipping time estimations, see the Shipping Information & Transit Times on the shipping page.
Ashley (Wood/Coal) Furnace Distribution Blower. The distribution blower is responsible for circulating room air around the furnace and into yourductwork. If the blower is not working as it should, the amount of heat transferred from the furnace into your home may be reduced. If the fan has been cleaned thoroughly and is not moving the same volume of air as it once did it may need to be replaced.
Install Instructions For Ashley Furnace Distribution Blower: 80594-AMP
1.) Disconnect the power from the unit.
2.) Remove the two screws holding the wire cover to the blower housing.
3.) Remove the wire cover.
4.) Untwist and remove the wire nuts from the wires coming from the blower to the conduit.
5.) Loosen and remove the lock nut holding the conduit to the wire housing (The conduit is now free from the blower).
6.) Next loosen the 4 bolts holding the blower to the furnace.
7.) You can now remove the blower from the unit (Check the gasket at this time. If it is damaged or worn it will need to be replaced).
8.) To install the new blower thread one bolt through the blower and gasket (This will help you position the gasket in place).
9.) Next insert and tighten all four bolts to the rear of the furnace.
10.) Remove the wire cover from the newly installed blower.
11.) Using a flathead screwdriver remove the knockout from the side of the blower housing.
12.) Pull out the wires from the blower wire housing and strip approximately a 1/4" of the plastic off of the ends of the wire.
13.) Insert the wires from the conduit through the knockout and position the conduit in place on the side of the wire housing.
14.) Replace the lock nut on the inside of the wire housing and tighten the nut to secure the conduit to the housing.
15.) Connect the black wire from the blower to the black wire from the conduit and the white wire from the conduit to the white wire from the blower.
16.) Reinstall the wire nuts.
17.) Reposition the cover and tighten the two screws.
18.) Plug in your unit and test the blower.
Troubleshooting
-If your distribution blower does not seem to be moving the same amount of air as it once did inspect and clean the blower. Distribution blowers will often draw dust and pet hair into the blades of the fan when operating. If the fan blades become packed with dust, hair, or other debris this can greatly reduce the efficiency of the blower. Often, a thorough cleaning will resolve this issue. If the blower continues to rotate at a slower speed after it has been cleaned or you hear excessive noise coming from the fan it may need to be replaced!
Warranty
Unfortunately, sometimes products do not work like they are supposed to. We offer a 90 day warranty on manufacturer defects. Some manufacturers
make this a very simple and easy process unfortunately others do not. Items must be used in accordance with the manufacturers guidelines to qualify for warranty replacement. Please
be advised that warranty claims for these parts may take up to 4 weeks for processing, and customers must cover shipping.
Shipping Info
This Item Qualifies For Free Shipping!
When Will My Order Ship?
All orders are typically processed within 24 hours of receiving payment and are shipped from us same day if placed before our shipping cutoff time (Monday - Friday: 12PM, Saturday: 10AM, Sunday: No Shipping), orders placed after our cutoff time are shipped the next morning.
Do You Offer Express Shipping?
Yes! Please note the shipping times are based on business days, weekends and holidays do not count to the delivery date. Please see our expedited ship time schedules here.
How Does Free Shipping Work?
Most orders over $99 qualify for free shipping! Orders which ship for free are shipped with either USPS or UPS based on our discretion. If you are using a PO box, free shipping orders will always go USPS.
Do You Ship To Canada?
We ship to Canada! We estimate USPS to take 4-10 days once receiving your package from us. We do not offer expedited shipping of any kind to Canada. Please allow an extra 2-5 days for all shipments to Canada. Free shipping is not available to Canada.
Do You Ship To Alaska Or Hawaii?
We ship to both Alaska and Hawaii! We do not offer next day or two day shipping to Alaska or Hawaii. Free shipping is not available to Alaska or Hawaii.
Do You Ship Outside The US Or Canada?
Unfortunately, at this time we do not offer international shipping other than to Canada.
Shipping Time Estimations
For information on shipping time estimations, see the Shipping Information & Transit Times on the shipping page.
Works perfect! Fits well and shipped on time. Would purchase again.
C
Christopher M.
Blower motor
Very easy to order and the package was delivered in a timely manner
A
Andrew F.
Fit Johnsons Energy Model J-9900 perfectly
Needed a new blower for my wood/coal furnace and this product fit perfectly and is such a smoother running blower than what was on the unit. And price you could not beat.
P
Patrick P.
Very pleased!
These blower fans work better than the ones that came with the stove originally.
Works perfect! Fits well and shipped on time. Would purchase again.
C
Christopher M.
Blower motor
Very easy to order and the package was delivered in a timely manner
A
Andrew F.
Fit Johnsons Energy Model J-9900 perfectly
Needed a new blower for my wood/coal furnace and this product fit perfectly and is such a smoother running blower than what was on the unit. And price you could not beat.
P
Patrick P.
Very pleased!
These blower fans work better than the ones that came with the stove originally.
