Char-Griller Auger Motor For 9020 & 9040 Series Pellet Grills: 900052-AMP

Char-Griller

• Heavy Duty
• Wood Fire Pro

1. On the bottom grate under the hopper, locate the 4 screws that hold it in place and remove them.
2. Remove the 2 screws holding in the controller.
3. Once removed, rotate the controller, so you can push it through where it was housed.
4. Unless already removed, clip the zip ties holding all the wires together.
5. Locate the 4 screws holding the hopper assembly on the grill and remove them (2 on either side).
6. Carefully remove the hopper assembly.
7. When replacing your feed motor, it's a good idea to remove the feed auger from the grill, make the motor swap and then reinstall the feed system as one piece.
8. Remove the 1/4-inch bushing screw (Screw holding the auger to the frame of the grill).
9. Disconnect the red wires from the main harness and loop them back through the burner mount so they are free.
10. With force, try to pull the auger motor back and forth by hand to try to loosen the jam.
11. Once the feed system is out of the grill, using 5/16" (8mm) socket wrench and a 4.5mm allan key, remove the Shear pin, freeing the Auger from the Auger motor.
12. Replace the motor, reconnect the shear pin, install the feeder assembly and lock the bushing in with the set screw. Reconnect your wiring and then reinstall the hopper shell.

This Item Qualifies For Free Shipping With Orders Over $99!