Hearthstone Wood Stove Glass Kit Right Side (Bennington 8350): 93-58507

Hearthstone Wood Stove IR Coated Right Side Glass Kit for Bennington 8350.  It is important to periodically inspect the glass and glass gasket on your wood stove to ensure you have a proper seal.  A crack in the glass or a missing / deteriorated gasket could allow smoke or flue gases to enter the room. Includes all the necessary mounting hardware and gasket for installation.

Measurements:  11 1/4" x 8 1/2"

A Note About Our Glass: Unlike some manufacturers, we do not use tempered glass. Tempered glass should NEVER be used in a wood fuel stove, it is not suitable for high heat use. Our glass is made to resist very high temperatures up to 1,400° F / 760° C with low thermal expansion.

Replacement For Part Numbers:

• 93-58507
• 3030-023

• Install Instructions PDF for Hearthstone 93-58507

Instructions:

1. To replace the glass, open the doors and lift them straight up and off the stove. Be sure to save the hinge pins and spacers for reassembly (Make a note of the number and placement of the spacers for the reassembly). Lay the doors on a flat surface with the glass panels facing up.

2.) Using a Phillips screwdriver, remove the screws that hold the glass clips in place. Retain the clips and screws for reassembly (New flat gasket sections should be used under the clips).

3.) Carefully remove and discard damaged glass. Remove the worn gasket from the door. Clean the surface with a wire brush and wipe it clean with a damp cloth.

4.) Pull the paper backing off the 3/16” rope, a little at a time. Press the adhesive side of the gasket down onto the door to seal and cushion the glass. Trim to fit.

5.) Place the new glass panel back onto the door and secure it with the clips and screws (Make sure a flat section of the gasket is placed between the glass and the clips to cushion the glass).

6.) Place the doors back onto the stove (Remember to replace the spacers and washers). 

Helpful Tips:

If you need to remove the glass or glass gasket it is a good idea to spray any fasteners with a product like WD40 or PB Blaster prior to this step. This will greatly reduce the possibility of stripping or breaking any screws/bolts during removal. When reinstalling the glass tighten the fasteners in a crisscross pattern. This will help to ensure there is even pressure on the glass (Do not overtighten). 

Please open and inspect your glass to make sure that it has arrived intact. Damage Claims for broken glass from shipping MUST be made within 72 hrs of delivery, no exceptions. Glass breaking from after installation is NOT covered under warranty, this is due to improper installation. If you do not feel comfortable replacing your glass, please contact a licensed technician. For instructions on proper glass installation, please read the instructions provided in the instructions tab.

This Item Qualifies For Free Shipping!