Traeger Auger Assembly for Select Models, KIT0082

Replacement Auger Shaft Assembly for Traeger Select Pro and Select Elite Pellet Grills.

NOTE: There can be exceptions to the list below. Some models made prior to 2016 were one-off promotional grills and may have been made with parts which are not 100% accurate to our descriptions. ALWAYS measure your auger shaft from end to end and compare it against our measurements.

• Large Traeger Grills like the BBQ075 Series, Texas Pro, Texas Elite, Pro 34, Eastwood 34, and other grills with a barrel length of 34" made prior to 2018 use auger shaft, KIT0023/ SUB005
• Mid-size Traeger Grills like the 22 Series, Century, Lil' Pig, Longhorn Steer , Executive, Professional, Mesa, Rolltop, and all grills with multiple burners, like XL and Double Trailer all use a 17" feed auger, KIT0022
• Small Traeger Grills for 055 Series, Tailgater, Bronson and all 20 Series, Tailgater, Renegade, Heartland, Bronson, Lone Star, Ridgeland all use auger shaft KIT0053/ SUB023
• Select Elite and Pro Grills use auger part, KIT0082
• Silverton 620 uses auger shaft, KIT0524. 
• Silverton 810 uses auger shaft, KIT0540
• Century 885 uses auger shaft , KIT0549
• Ironwood 885 and Pro 780 use auger shaft, KIT0431/ SUB1519
• Ironwood 650 and Pro 575 use auger shaft, KIT0426

These are all of the most popular Auger Shaft Sizes, to view all of the various lengths with pictures, here is a link to the entire Traeger Feeder Parts Collection

Replacement For Part Number:

• KIT0082

UPC: 634868919664

Upgrade or replace your wiring & connectors

Shop for connectors, adapters, service tools, and more.

Shop now

1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord.

2) CAUTION! If the Grill is still hot, allow it to thoroughly cool.

3) Remove any covers necessary to access the Auger Drive Motor.

4) Remove the screw connecting the Auger Drive Motor shaft to the Auger shaft and the screw retaining the Auger Bushing into the Auger Tube.

5) With a small pipe wrench or locking pliers on the Auger shaft, turn the Auger counterclockwise. It will turn hard until it breaks free, then the Auger will turn freely.

6) Remove the Auger and clean all Pellets, ash or foreign objects from the Auger, Auger Tube, and Firepot. (See instructions for proper handling and disposal of ash in Section Five)

7) Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the Auger Tube and sand it if needed. Vacuum the sanding grit out of the Auger Tube and Firepot when finished. Check that the Auger rotates freely.

8) Re-attach the Auger shaft to the Auger Drive Motor shaft.

Auger shafts can often bind up inside the feed tube if they become warped. This can happen if the pellets in the feed tube become wet. To verify if you warped, remove the shaft and roll it across a flat surface. If it is warped, you will notice the slight bend as it rolls.

This Item Qualifies For Free Shipping With Orders Over $99!