Vogelzang High Temperature Therm-O-Disc W/ Manual Reset (L200F): 80601-AMP

Vogelzang

• VG5770 (opens in new tab)
• VG5790 (opens in new tab)

Instructional Documents:

• Install Instructions PDF for Vogelzang 80601

1.) Unplug the stove.

2.) Remove any rear or side panels needed to gain access to the switch.

3.) Gently pull the spade connectors from the tabs on the switch.

4.) Unscrew the fasteners holding the switch in place and remove the old switch (If your switch uses a gasket, take care not to damage it when removing the old switch).

5.) Position the new switch and gasket (If used).

6.) Reinstall the previously removed fasteners.

6.) Connect the wires to the new switch (It does not matter which wire goes to which side).

7.) Reinstall any previously removed panels.

8.) Plug in the stove and perform a test burn.

This switch should be "NC" or normally closed or "ON". If the switch detects 200°F or more the switch rolls out to "OPEN" and the power is cut telling the controller to stop feeding and the room blower will run non-stop. Pressing the red button on the switch will "RESET" the switch to the NC position provided the switch's metal face is <200°F on the metal face.

High limit switches do not usually fail without some kind of event, like a power surge. Generally if the switch fails the reset button will no longer hold the switch in the normally closed position. If this has happened, it would be a good idea to remove the controller and inspect the electrical circuitry on both sides of the board for signs of a power arc or controller board component failure. IF replacing the switch does not remedy the problem, you may need a new controller.

This Item Qualifies For Free Shipping With Orders Over $99!