USSC Pellet Stove Exhaust Blower Assembly: 80602

USSC Pellet Stove Exhaust Blower Assembly. The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air into the stove. If the blower is not running as it should, smoke/flue gas may enter the room. You may also notice a lazy flame and a poor burn as a result of inadequate combustion air being delivered to the fire.

UPC: 012685806020

Replacement For Part Number:

• 80602

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For USSC Pellet Stove Exhaust Blower Assembly: 80602

Instructional Documents

• Install Instructions PDF for US Stove 80602

Instructional Notes

1. Unplug the stove.
2. Open the service panel on the side of the unit.
3. Locate and remove the high-limit Therm-O-Disc from the blower housing.
4. Remove the two wire leads running from the wiring harness to the blower motor.
5. Next, remove the bolts holding the blower housing to the stove (If the venting is connected to the stub on the back of the blower housing, it will need to be disconnected).
6. Remove the blower (The gasket between the blower housing and stove should be replaced at this time).
7. Position the new blower assembly and gasket in place and reinstall the previously removed bolts.
8. Reconnect the venting if it was disconnected (Remember to apply high-temp silicone at the connection point).
9. Reinstall the high-limit Therm-O-Disc.
10. Connect the previously removed wires to the new blower motor.
11. Plug in the unit and test the motor.

Troubleshooting Notes

-The exhaust blower is responsible for removing smoke from the unit and pulling combustion air into the stove. If you notice a lazy flame when your stove is burning or smell smoke you should shut down the stove.

-Carefully inspect all gaskets, clean the stove/venting, and inspect the area around the combustion blower.

-If all gaskets are sealing properly and the stove/venting is clean, the combustion blower may need to be replaced.

This Item Qualifies For Free Shipping!