Englander Door Gasket. (7FT): AC-DGKEP

Englander Door Gasket for EP & EPI Only

The gasket kit designed specifically for the Evolution Pellet stove models. Gasket measures 3/4" round, 7 Ft. Long

Note: This gasket requires the use of gasket cement for installation.

UPC: 794909702423

Replacement For Part Number:

• AC-DGKEP

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Englander Door Gasket. (7FT): AC-DGKEP

Instructional Documents

• Install Instructions PDF for Englander AC-DGKEP

Instructional Notes

1.) Make sure the stove is shut down and has completely cooled.

2.) Begin by gently pulling the old gasket out of the channel on the door. You should wear gloves for this step.

3.) Using a flathead screwdriver scrape out any old adhesive from the channel of the door.

4.) Once the channel on the door is clean, apply a bead of gasket cement into the gasket channel on the door.

5.) Starting at the bottom center of the door begin to push your new gasket into the channel.

6.) Once the gasket is in place work your way around the door gently pressing on the gasket to ensure it is seated correctly.

7.) You will likely need to trim the gasket. It is best to start off by trimming a little at a time. If you cut too much off you may not have enough gasket left to complete the seal around the door.

8.) Close the door to confirm that the gasket has been seated correctly.

9.) Keep the door closed until the gasket cement/adhesive cures. This may vary depending on the brand and type of adhesive/cement you use. Some cements require the stove to be fired in order for the adhesive to cure properly. Make sure you follow the directions listed on the back of the sealant/cement tube!

This Item Qualifies For Free Shipping With Orders Over $99!