Heatilator Eco Choice Burnpot Clean-out Cover With Wingscrews: 1-00-06623-AMP

This burn pot cleanout cover with 2 wingscrews is located at the front of all Harman pellet stoves and pellet inserts that are equipped with automatic ignition. Loosening the screws allows you to remove the plate to get access to the interior of the burn pot for cleaning and maintenance of the airways and the igniter.

UPC: 652174610891

Replacement For Part Number:

• 1-00-06623

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Heatilator Eco Choice Burnpot Clean-out Cover With Wingscrews: 1-00-06623-AMP

Instructional Documents

• Install Instructions PDF for Heatilator 1-00-06623

Instructional Notes

Installation:

1.) Make sure the unit is shut down and the stove is cool.

2.) Open the main load door and ash door.

3.) Remove the ash pan (This will give easier access to the cover on most stoves).

4.) Locate the two thumb screws and remove (if the thumb screws are stuck in place, spray a small amount of penetrating oil on the thumb screws and let it sit. A pair of pliers can be used to loosen the screws).

5.) After loosening the screws, the cover plate can be removed. If you are replacing the screws, they can be removed at this time as well.

6.) Position the new cover plate in place and tighten the thumb screws. Do not over-tighten! If you are replacing the screws at this time you should thread both screws into the holes on the bottom of the burn pot first, then position the cover plate in place and tighten each thumb screw.

7.) Confirm that the plate is seated tightly against the bottom of the burn pot and there are no gaps present.

Troubleshooting Notes

-If your stove is not igniting or burning correctly the cover plate should be removed and the inside of the burn pot should be cleaned/vacuumed.

-It is also important to make sure that the cover plate is seated firmly against the bottom of the burn pot. Any gap or opening will allow air to be drawn in at the bottom of the burn pot. This can cause missed ignition and an inefficient burn.

-At times a gap between the cover plate and the bottom of the stove can be resolved by simply tightening the thumb bolts. If the plate is warped it should be replaced.

This Item Qualifies For Free Shipping With Orders Over $99!