Install Instructions For Lennox Fireplace Blower Kit: H7841
Instructional Documents
Instructional Notes
Installation Instructions:
1) Turn off the fireplace and allow it to cool before proceeding.
2) If the appliance is connected to 120 volt power, disconnect the power.
3) Shut off the gas supply to the fireplace.
4) Open and remove the lower compartment door.
5) Remove the log set and loose media. Remove the sub-floor. Remove the burner, loosen and remove the screws securing the GTA (Gas Train Assembly) to the firebox bottom. Lift the GTA up and away as far as the flex line will allow. If required, disconnect flex line and completely remove the GTA. Install the blower against the firebox rear wall and secure by bending tabs up.
For more installation instructions please refer to the link below.