Breckwell Pellet Stove Exhaust Blower Motor: 80473-AMP

Replacement exhaust blower motor for select Breckwell pellet stoves. See compatible tab for more info.

Includes:

• Blower Motor (Motor Only, No Housing)
• Round Mounting Gasket
• Male to Male Connector
• Female to Female Connector

Fitment Note (SP6000 Models):  Only for 2012 and newer

Install Note: By default, this blower comes wired with one male and one female wire lead. If you require two female leads, convert the male lead with the female to female connector. If you require two male leads, convert the female lead with the male to male connector.

Note: If you need the complete assembly with the blower attached to the housing, see part SP4L-80473

• 80473

Need to upgrade or replace your wiring & connectors?

Shop for connectors, adapters, service tools, and more. Shop now

Compatible Models

To replace the exhaust blower:

1. Unplug the unit
2. Open the service panel
3. Locate the exhaust blower. If your unit has the original OEM blower, you may have to remove the entire blower assembly if the motor cannot be removed from the hub. This will also involve removing the vent from the end of the assembly. If you have a Breckwell Insert, you will need to remove the entire off-set assembly from the of blower assembly and attach it to the new assembly if you have a hub-less motor.
4. Disconnect wiring
5. Replace blower assembly along with any gaskets that were disturbed (included).
6. Reconnect venting if it was disconnected
7. Reattach the wiring
8. NOTE: if the venting was removed, make sure to apply RTV silicone to the venting adapter and secure with a single self tapping screw.