Breckwell OEM Exhaust Blower, 80473

Replacement Breckwell Exhaust Blower. Includes the motor and housing.

Compatible with the following models:

• SP1002 Big E II
• SP6000 Heartland (2012 and newer)

The combustion exhaust blower delivers a steady stream of forced air (negative draft) through the stove in order to keep the flame burning, while allowing you to set your heat range to your desired comfort level. Our pellet stove exhaust blower comes with the complete assembly with gasket and pipe adaptor and mounts securely in place of your existing blower. This blower comes with everything you need for installation including wire leads that make installation a breeze.

Technical Specs:

• 115 Volts
• 0.69 Amps
• 2900 RPM
• 12 Fin, 4-5/8" Fan Blade
• Two Wire Leads Hook Up 

• 80473

Need to upgrade or replace your wiring & connectors?

Shop for connectors, adapters, service tools, and more. Shop now

Compatible Models

To replace the exhaust blower:

1. Unplug the unit
2. Open the service panel
3. Locate the exhaust blower. If your unit has the original OEM blower, you may have to remove the entire blower assembly if the motor cannot be removed from the hub. This will also involve removing the vent from the end of the assembly. If you have a Breckwell Insert, you will need to remove the entire off-set assembly from the of blower assembly and attach it to the new assembly if you have a hub-less motor.
4. Disconnect wiring
5. Replace blower assembly along with any gaskets that were disturbed (included).
6. Reconnect venting if it was disconnected
7. Reattach the wiring
8. NOTE: if the venting was removed, make sure to apply RTV silicone to the venting adapter and secure with a single self tapping screw.