Breckwell Side Glass (10-3/4" X 5-3/8" ): C-D-802-B-AMP

Breckwell Pellet Stove Side Glass (P2700/2000).  The glass on your stove allows you to view the fire and helps transfer heat into the room.  It is important to periodically inspect the glass on your stove.  If you notice black or brown streaks on the glass it may indicate that there is an air leak.  If the glass is cracked or has an excessive haze (cloudy appearance) it should be replaced

Measurements: 10-3/4" X 5-3/8" 

*Sold individually. The glass does NOT come with a gasket (C-G-033).*

A Note About Our Glass: Unlike some manufacturers, we do not use tempered glass. Tempered glass should NEVER be used in a wood fuel stove, it is not suitable for high heat use. Our glass is made to resist very high temperatures up to 1,400° F / 760° C with low thermal expansion.

Replacement For Part Number:

• C-D-802-B

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Breckwell Side Glass (10-3/4" X 5-3/8" ): C-D-802-B-AMP

Instructional Documents

• Install Instructions PDF for Breckwell C-D-802-B

Instructional Notes

GLASS REPLACEMENT PROCEDURE (May Vary Depending On Model)

1. Ensure the appliance is not in operation and is thoroughly cooled.

2. Remove screw and glass clips.

3. Remove the glass from the door frame.

4. If the glass is broken, carefully remove and discard each broken piece to avoid cuts. Discard window gasket.

5. Replace the new gasket starting at the bottom of the glass and working along the edges (Be sure to center the gasket channel on the glass).

6. Trim to length and butt ends together.

7. Perform replacement procedure in reverse order after replacing glass and gasket.

8. When replacing the glass be not to overtighten the screws and clips!

Troubleshooting Notes

Glass Care: The following usage and safety tips should be observed:

1. Inspect the glass regularly for cracks and breaks. If you find a crack or break in the glass, immediately begin shutting down the unit. Do not operate the unit until the broken glass is replaced.

2. Do not slam the door.

3. Do not clean the glass with materials that may scratch (or otherwise damage) the glass. Scratches on the glass can develop into cracks or breaks during operation.

4. Never attempt to clean the glass while the unit is hot. If deposits are not very heavy, normal glass cleaners are adequate using a soft, non-abrasive cleaning pad. Heavier deposits may be removed with oven cleaners.

5. Never put substances that can ignite explosively in the unit. Even small explosions in confined areas can blow out the glass.

Please open and inspect your glass to make sure that it has arrived intact. Damage Claims for broken glass from shipping MUST be made within 72 hrs of delivery, no exceptions. Glass breaking from after installation is NOT covered under warranty, this is due to improper installation. If you do not feel comfortable replacing your glass, please contact a licensed technician. For instructions on proper glass installation, please read the instructions provided in the instructions tab.

This Item Qualifies For Free Shipping With Orders Over $99!