Harman Burn Pot Weldment: 1-10-05802

Harman

• Invincible Insert
• Invincible RS
• Invincible T
• P61-A
• P61-C
• P61A
• Pellet Pro II

1. Unplug your stove and make sure that the unit is cool to the touch.
2. The igniter is located inside if the burnpot. From the rear of the stove, find the yellow and light blue colored wires that are coiled up and secured to the wiring harness. Cut the zip ties that hold this collection of wire together (When the burn pot is removed, this extra wire is what will be fed back into the neck of the burn pot).
3. Locate and remove the (4) 1/2" nuts that secure the burnpot to the feeder weldment's threaded rods (You may need a universal joint at the end of your socket wrench to make the connection at the top nuts).
4. Pull the burnpot assembly forward until the yellow and light blue wires are visible, then disconnect the igniter wires. Now the burn pot is free to come out of the stove
5. Remove the two 5/16" screws that attach the igniter cradle in to the burnpot and remove the igniter assembly.
6. If you are replacing your igniter, do this now while the burnpot is free from the stove.
7. Make sure to run the wires for the igniter through the right-side opening at the rear of the burn pot
8. Replace your burnpot gasket, make sure your yellow and light blue wires are passing through the hole and through the center of the gasket.
9. Connect your igniter wires and pull the yellow and light blue wires from the back of the stove so that the disconnects pass backward through the opening (Try to take out as much slack in the igniter wires as possible so that they aren't pinch by the burnpot when it is fit into place).
10. Replace your new burn pot over the threaded rods and tighten down all 4 1/2" hex nuts. You will feel the new gasket compress as you tighten the burnpot down, this is normal (It is best to tighten the nuts by hand at the start. Then proceed by tightening in a crisscross pattern. This will ensure that the burn pot seats evenly against the back of the unit).
11. Replace the clean out cover and secure your wires in the rear of the stove.

-The burnpot is a central part of the Harman Pro Pellet Feed System. Often, your burn pot will last for the life of the unit. It is important to periodically inspect the pot to make sure it is not warping and there are no cracks forming. If you notice any of these issues the burn pot should be replaced.

If you are having delayed ignitions and can verify that the igniter is getting hot:

1. Tighten the four 1/2" nuts that secure the burnpot.
2. Replace your door gasket and the ash pan gasket if you have separate doors
3. Look at your door handle to make sure the components of the handle and the catch on the stove are in working order
4. Make sure the hopper lid is making a tight seal.

This Item Qualifies For Free Shipping!