Breckwell P22 Maverick Pellet Stove Repair and Replacement Parts

Breckwell Pellet Stove Exhaust Blower.  The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air into the sto...

Breckwell Pellet Stove Distribution/Convection Blower.  This blower circulates air around the stove and across the heat exchanger.  It is responsib...

Replacement 6" Exhaust Motor Gasket. **Motor side 4 7/8" ID 6" OD** Note: This will fit stove models that have the 5 3/4" quick change style hub ...

Breckwell Pellet Stove Igniter (250W/300W).  The igniter allows your unit to auto light when there is a call for heat.  It works by superheating th...

Breckwell Thermodisc This Breckwell Thermodisc Low Temp Fits All Models Except P6000 The Low-Limit or Proof of Fire Thermodisc is mounted on the C...

Breckwell 6" Round Combustion Blower Gasket.  The combustion blower gasket makes a seal between the blower and blower housing.  A proper seal in th...

Breckwell Thermodisc High Temp #C-E-090-21 This important safety device will monitor heat in the stove. If your stove gets too hot the switch will ...

Breckwell Thermodisc This Breckwell Thermodisc Low Temp Fits All Models Except P6000 The Low-Limit or Proof of Fire Thermodisc is mounted on the C...

Replacement burnpot for Breckwell pellet stoves. This burnpot fits most of the newer stoves that have an igniter. Breckwell Burnpot Assembly. This ...

This burn grate is 3-9/16" wide, stainless steel will fit on the following Breckwell Pellet Stoves: P22 - post 1994 P23 - post 1994 P24 - post 19...

Breckwell Door Glass Gasket. The glass gasket provides a tight seal between the door glass and door frame.  A leak around the door glass can cause ...

Breckwell Vacuum Switch C-E-201 This Vacuum/Air Switch is used on all Pellet and Multi-Fuel Stoves. This is a safety sensor that will measure the a...

Replacement Pellet Stove Exhaust Blower Gasket. Fits many models (Lennox, Breckwell, Enviro, & More).  This gasket seals between the exhaust bl...

This important safety switch cuts power to the feed system if the pellet stove overheats and will automatically reset once the stove has cooled.

Breckwell Exhaust Blower Assembly.  The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air into the stove. ...

Replacement 1 RPM auger motor for all Breckwell Pellet Stoves with digital control boards with 5 heat levels, to include all pellet stoves made aft...

Replacement Breckwell, Brass Auger Bushing. Top & Bottom brass (No Threads).

Breckwell Pellet Stove Exhaust Blower Gasket.  This gasket seals between the exhaust blower housing and the unit.  It is important to inspect this ...

Breckwell Pellet Stove Igniter (250W/300W).  The igniter allows your unit to auto light when there is a call for heat.  It works by superheating th...

Breckwell 1/8" Auger Pin For All Models

Breckwell Control Board Decal For the 1RPM Board Replacement Decal For Control Panel A-E-101.  Decal colors have been updated to Red & Black in...

Breckwell Rope Door Gasket (5/8" x 6').  It is important that there is a good seal between the door and the body of your stove.  A poor seal can ca...

Replacement Control Board Fuse Type 5 AMP 125V. This is the master fuse for most pellet stoves in the USSC/ Breckwell/ Vozelgnag product line.

This is an replacement OEM control panel with 4-speed settings for select Breckwell pellet stoves that use a 1RPM auger motor. This part replaces m...

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

This appliance collar mount, also known as the tailpipe, will fit with most manufacturer exhaust blowers. Please check the dimensions of the one yo...

This is the first generation of digital control panels for most Pellet stoves. If you have the old style analog board with dials and rocker switche...

1 RPM auger shaft for Early P22 and P23 Breckwell pellet stoves. If your controller has only 4 heat level settings, this is the correct auger shaft...

Breckwell Replacement Door Handle Assembly for models P23 P24 & Big E 1000

Breckwell Pellet Stove Convection Blower Gasket (Silicone). This gasket creates a seal between the blower and the body of the stove.  This helps en...

Breckwell Complete Door Handle Assembly For P22, A-H-KIT22

Circuit board upgrade kit for Breckwell pellet stoves. This kit also fits some P23 models. This kit is an upgrade for the old-style analog boards t...

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

Clip Rotor 5/8 Locking Used with the Bushtop. Fits USSC 5040 And All Breckwell Models

Auger Biscuit for Breckwell Stoves. Includes Bushtop

Breckwell Pellet Stove Exhaust Blower W/ Housing.  The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air i...

Replacement Breckwell  burnpot assembly for pellet stoves. This burnpot fits most of the newer stoves that have an igniter. This pot comes with the...

Breckwell Pellet Stove Convection/Room Blower. This blower circulates air around the stove and across the heat exchanger.  This fan is responsible ...

Breckwell Burnpot Insert SS Stainless steel burnpot insert for A-S-Burnpot & A-S-Burnpotni. Part #A-S-INSERT Fits the following models: P22 - ...

Breckwell Pellet Stove OEM Combustion Blower (W/ Housing).  The exhaust blower is responsible for drawing smoke out of the unit and pulling combust...

Breckwell Pellet Stove Power Supply Cord.  This cord is the main connection responsible for bringing power to the stove. The cord plugs into the st...

Breckwell Replacement Door Handle Kit. Fits many models. Some washers will not be used on certain models.

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

Replacement of Part #C-E-017 1 RPM Gleason avery auger motor for Breckwell pellet stoves. This motor fits all Breckwell pellet stove models produce...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

Breckwell Outer Burnpot This is the same as the A-S-BURNPOT just without the stainless steel insert. Replacement burnpot for Breckwell pellet stove...

Exhaust Blower Mount Fits on many models. This mount, also known as the tailpipe, will fit with other manufacturer exhaust blowers. Please check th...

This is an aftermarket burnpot that we have welded ourselves. Breckwell A-S-Burnpot P2K burnpot assembly. There is 1" in between the two holes on ...