Breckwell Pellet Stove Distribution/Convection Blower. This blower circulates air around the stove and across the heat exchanger. It is responsible for transferring warm air into the room. If your blower is not functioning correctly, it can greatly reduce the amount of heat you get from the stove! If the blower is not moving the same amount of air as it once did it may need to be cleaned or replaced.!
Important Notes:
This blower will not work with some older P2700 units. The mounting plate dimensions are 4″ X 4 3/8″
* Some of these blowers have arrived to us with the motor mounted on the blower housing 30 degrees offset from where it should be. In most cases this will not cause an installation issue. On some models it may make the motor tight to install. The motor can be rotated on the housing by removing the blower wheel set screw and then accessing the 3 mounting nuts inside the housing. Once it's free, rotate the motor so that the plastic casing on the coil is facing the rear of the blower then reconnect the nuts and blower wheel.*
Please see the instructions for resetting the blower speed when replacing your blower
Note: If you have an older Breckwell stove with mounting plate dimensions 5" x 5 1/2" you will need an adapter plate A-MP-KIT
Fitment Note: Some models of P1000 Big E stove require the blower motor to be rotated counter clockwise by one screw to fit. This is made easy by removing the impeller and then unscrewing the motor, then turning 1/3 turn, and reattaching it.
It is suggested to replace the high limit safety snap disc switch whenever you are replacing a room blower, C-E-090-21
Replacement For Part Numbers:
- A-E-033
- 11-1210
- 80647
- PP7310
- C-E-029
View Compatible Models
UPC: 012685000978
