Skip to main content
Skip to main content
Product title:

Breckwell Distribution/Convection Blower (Fasco): A-E-033-AMP

Product rating:
Product price:
Save 17%
Original Price $179.99
Current Price $149.99

A $350.00 Savings over the OEM

Product SKU ! A-E-033-SP4L-2
Product MPN ! A-E-033
Product availability: In Stock
Bullet point features

Frequently Bought Together

Total Price: $195.96

Description

Breckwell Pellet Stove Distribution/Convection Blower.  This blower circulates air around the stove and across the heat exchanger.  It is responsible for transferring warm air into the room.  If your blower is not functioning correctly, it can greatly reduce the amount of heat you get from the stove!  If the blower is not moving the same amount of air as it once did it may need to be cleaned or replaced.

Important Notes:

This blower will not work with some older P2700 unitsThe mounting plate dimensions are 4″ X 4 3/8″

* Some of these blowers have arrived to us with the motor mounted on the blower housing 30 degrees offset from where it should be.  In most cases this will not cause an installation issue.  On some models it may make the motor tight to install.  The motor can be rotated on the housing by removing the blower wheel set screw and then accessing the 3 mounting nuts inside the housing.  Once it's free, rotate the motor so that the plastic casing on the coil is facing the rear of the blower then reconnect the nuts and blower wheel.* 

Please see the instructions for resetting the blower speed when replacing your blower

Note: If you have an older Breckwell stove with mounting plate dimensions 5" x 5 1/2" you will need an adapter plate A-MP-KIT

Fitment Note: Some models of P1000 Big E stove require the blower motor to be rotated counter clockwise by one screw to fit. This is made easy by removing the impeller and then unscrewing the motor, then turning 1/3 turn, and reattaching it.

It is suggested to replace the high limit safety snap disc switch whenever you are replacing a room blower, C-E-090-21


Replacement For Part Numbers:

  • A-E-033
  • 80647
  • PP7310
  • C-E-029

View Compatible Models

UPC: 012685000978

Compatible Models

    Breckwell

  • P1000 Big E
  • P2000 Tahoe
  • P22 Maverick
  • P22I Maverick Insert
  • P23 Sonora
  • P24 Blazer
  • P24I Blazer Insert
  • P26 Cadet
  • P2700 Mojave
  • P32i Cadet
  • P4000 Classic Cast
  • P6000 Multi-Fuel
  • P7000 Solstice

Technical Specs

Volts 115 AC
Cycles 60Hz
Amps 2.1 LFA
RPM 3000
Wiring Connectors 1 Male 1 Female

Videos

Instructions

Install Instructions For Breckwell Distribution/Convection Blower (Fasco): A-E-033-AMP
  1. Unplug the unit from the power source
  2. Remove the rear panel, you may need to remove the venting from the unit depending upon your installation
  3. Remove the side panel which has the the controller.
  4. Disconnect all of the wires from the controller and set the panel aside
  5. Remove the wires for the blower which is located behind the control area
  6. Remove the blower mounting screws from the rear wall of the stove
  7. Install your new blower with a new gasket
  8. Reconnect the blower wiring
  9. Reconnect the wires to the the controller
  10. Reconnect rear panel, venting and power cord.

Troubleshooting

-The distribution blower is the fan responsible for blowing hot air into the room. Often times this blower will become coated in dust and pet hair. If you feel like the blower is not moving as much air as it once did, the motor should be cleaned. If this does not resolve the issue the motor may need to be replaced.


-Many stoves are also equipped with a high-limit sensor. If your high-limit sensor is tripping or you are receiving a high-limit error code on your board this may indicate that the blower is not moving as much air as it should.


Warranty

Unfortunately, sometimes products do not work like they are supposed to. We offer a 90 day warranty on manufacturer defects. Some manufacturers make this a very simple and easy process unfortunately others do not. Items must be used in accordance with the manufacturers guidelines to qualify for warranty replacement. Please be advised that warranty claims for these parts may take up to 4 weeks for processing, and customers must cover shipping.

Shipping Information

This Item Qualifies For Free Shipping With Orders Over $199!

When Will My Order Ship?

All orders are typically processed within 24 hours of receiving payment and are shipped from us same day if placed before our shipping cutoff time (Monday - Friday: 12PM, Saturday: 10AM, Sunday: No Shipping), orders placed after our cutoff time are shipped the next morning.

Do You Offer Express Shipping?

Yes! Please note the shipping times are based on business days, weekends and holidays do not count to the delivery date. Please see our expedited ship time schedules here.

How Does Free Shipping Work?

Most orders over $199 qualify for free shipping! Orders which ship for free are shipped with either USPS or UPS based on our discretion. If you are using a PO box, free shipping orders will always go USPS.

Do You Ship To Canada?

We ship to Canada! We estimate USPS to take 4-10 days once receiving your package from us. We do not offer expedited shipping of any kind to Canada. Please allow an extra 2-5 days for all shipments to Canada. Free shipping is not available to Canada.

Do You Ship To Alaska Or Hawaii?

We ship to both Alaska and Hawaii! We do not offer next day or two day shipping to Alaska or Hawaii. Free shipping is not available to Alaska or Hawaii.

Do You Ship Outside The US Or Canada?

Unfortunately, at this time we do not offer international shipping other than to Canada.

Shipping Time Estimations

For information on shipping time estimations, see the Shipping Information & Transit Times on the shipping page.

Learn More About Our Shipping Information
Jump back to product information tab navigation

Description

Breckwell Pellet Stove Distribution/Convection Blower.  This blower circulates air around the stove and across the heat exchanger.  It is responsible for transferring warm air into the room.  If your blower is not functioning correctly, it can greatly reduce the amount of heat you get from the stove!  If the blower is not moving the same amount of air as it once did it may need to be cleaned or replaced.

Important Notes:

This blower will not work with some older P2700 unitsThe mounting plate dimensions are 4″ X 4 3/8″

* Some of these blowers have arrived to us with the motor mounted on the blower housing 30 degrees offset from where it should be.  In most cases this will not cause an installation issue.  On some models it may make the motor tight to install.  The motor can be rotated on the housing by removing the blower wheel set screw and then accessing the 3 mounting nuts inside the housing.  Once it's free, rotate the motor so that the plastic casing on the coil is facing the rear of the blower then reconnect the nuts and blower wheel.* 

Please see the instructions for resetting the blower speed when replacing your blower

Note: If you have an older Breckwell stove with mounting plate dimensions 5" x 5 1/2" you will need an adapter plate A-MP-KIT

Fitment Note: Some models of P1000 Big E stove require the blower motor to be rotated counter clockwise by one screw to fit. This is made easy by removing the impeller and then unscrewing the motor, then turning 1/3 turn, and reattaching it.

It is suggested to replace the high limit safety snap disc switch whenever you are replacing a room blower, C-E-090-21


Replacement For Part Numbers:

  • A-E-033
  • 80647
  • PP7310
  • C-E-029

View Compatible Models

UPC: 012685000978

Compatible Models

    Breckwell

  • P1000 Big E
  • P2000 Tahoe
  • P22 Maverick
  • P22I Maverick Insert
  • P23 Sonora
  • P24 Blazer
  • P24I Blazer Insert
  • P26 Cadet
  • P2700 Mojave
  • P32i Cadet
  • P4000 Classic Cast
  • P6000 Multi-Fuel
  • P7000 Solstice

Technical Specs

Volts 115 AC
Cycles 60Hz
Amps 2.1 LFA
RPM 3000
Wiring Connectors 1 Male 1 Female

Instructions

Assembly Instructions For Breckwell Distribution/Convection Blower (Fasco): A-E-033-AMP

  1. Unplug the unit from the power source
  2. Remove the rear panel, you may need to remove the venting from the unit depending upon your installation
  3. Remove the side panel which has the the controller.
  4. Disconnect all of the wires from the controller and set the panel aside
  5. Remove the wires for the blower which is located behind the control area
  6. Remove the blower mounting screws from the rear wall of the stove
  7. Install your new blower with a new gasket
  8. Reconnect the blower wiring
  9. Reconnect the wires to the the controller
  10. Reconnect rear panel, venting and power cord.

Troubleshooting

-The distribution blower is the fan responsible for blowing hot air into the room. Often times this blower will become coated in dust and pet hair. If you feel like the blower is not moving as much air as it once did, the motor should be cleaned. If this does not resolve the issue the motor may need to be replaced.


-Many stoves are also equipped with a high-limit sensor. If your high-limit sensor is tripping or you are receiving a high-limit error code on your board this may indicate that the blower is not moving as much air as it should.


Warranty

Unfortunately, sometimes products do not work like they are supposed to. We offer a 90 day warranty on manufacturer defects. Some manufacturers make this a very simple and easy process unfortunately others do not. Items must be used in accordance with the manufacturers guidelines to qualify for warranty replacement. Please be advised that warranty claims for these parts may take up to 4 weeks for processing, and customers must cover shipping.

Shipping Info

This Item Qualifies For Free Shipping With Orders Over $199!

When Will My Order Ship?

All orders are typically processed within 24 hours of receiving payment and are shipped from us same day if placed before our shipping cutoff time (Monday - Friday: 12PM, Saturday: 10AM, Sunday: No Shipping), orders placed after our cutoff time are shipped the next morning.

Do You Offer Express Shipping?

Yes! Please note the shipping times are based on business days, weekends and holidays do not count to the delivery date. Please see our expedited ship time schedules here.

How Does Free Shipping Work?

Most orders over $199 qualify for free shipping! Orders which ship for free are shipped with either USPS or UPS based on our discretion. If you are using a PO box, free shipping orders will always go USPS.

Do You Ship To Canada?

We ship to Canada! We estimate USPS to take 4-10 days once receiving your package from us. We do not offer expedited shipping of any kind to Canada. Please allow an extra 2-5 days for all shipments to Canada. Free shipping is not available to Canada.

Do You Ship To Alaska Or Hawaii?

We ship to both Alaska and Hawaii! We do not offer next day or two day shipping to Alaska or Hawaii. Free shipping is not available to Alaska or Hawaii.

Do You Ship Outside The US Or Canada?

Unfortunately, at this time we do not offer international shipping other than to Canada.

Shipping Time Estimations

For information on shipping time estimations, see the Shipping Information & Transit Times on the shipping page.

Learn More About Our Shipping Information

Customer Reviews

Based on 69 reviews
97%
(67)
3%
(2)
0%
(0)
0%
(0)
0%
(0)
D
David V.
Excellent service!

Ordered a new convection blower for my Big E and it arrived quickly with no hassle a reasonable price and was a correct part, there is really nothing else to say. They get it done right.

J
John C.

Blower Assembly works great perfect

M
Miguel G.
Great Service!!

I ordered a blower for my pellet stove and received it right away, works perfect 👍🏼 thanks

J
Janet M.
Excellent advice and perfect parts for our pellet stove

Your kind/patient representative answered all questions and provided great advice. I've ordered parts from you several times when our old Breckwell stove needed help. Each time the parts came very quickly and each time were the perfect fit and function. This time, especially, the part (a blower) is helping our stove work better than ever before...the high/low function works now and it never did before...the large house (upstate NY) didn't need anything to heat it today (snowing outside) other than our stove. Thank you! So good to know you're there to help so exceptionally well.

R
Robert M.
Great selection

Did a search and after many ads was frustrated and found Stove & Grill Parts for Less. I really like the selection of aftermarket and OEM selections that they had for different parts. Part was in stock shipped the next day and my local supply house was still looking for the part when I called them back to let them know I found the part. Thanks

QUESTIONS & ANSWERS

If your question does not concern this specific product, use our contact form
Ask a Question
  • Have an older Big E with a convection blower # C-E-033 is that different from A-E-033?

    The only difference is that you original blower may have a soup can cover over the motor. Newer style has an exposed motor and a cooling fan (disc) on top. If this motor is too tall you can pop off the cooling fan.

Customer Reviews

Based on 69 reviews
97%
(67)
3%
(2)
0%
(0)
0%
(0)
0%
(0)
D
David V.
Excellent service!

Ordered a new convection blower for my Big E and it arrived quickly with no hassle a reasonable price and was a correct part, there is really nothing else to say. They get it done right.

J
John C.

Blower Assembly works great perfect

M
Miguel G.
Great Service!!

I ordered a blower for my pellet stove and received it right away, works perfect 👍🏼 thanks

J
Janet M.
Excellent advice and perfect parts for our pellet stove

Your kind/patient representative answered all questions and provided great advice. I've ordered parts from you several times when our old Breckwell stove needed help. Each time the parts came very quickly and each time were the perfect fit and function. This time, especially, the part (a blower) is helping our stove work better than ever before...the high/low function works now and it never did before...the large house (upstate NY) didn't need anything to heat it today (snowing outside) other than our stove. Thank you! So good to know you're there to help so exceptionally well.

R
Robert M.
Great selection

Did a search and after many ads was frustrated and found Stove & Grill Parts for Less. I really like the selection of aftermarket and OEM selections that they had for different parts. Part was in stock shipped the next day and my local supply house was still looking for the part when I called them back to let them know I found the part. Thanks