Harman Feeder Motor For Advance, Accentra & Certain XXV (4RPM CCW): 3-20-08752

This "counter-clock-wise" 4 RPM Auger Feed Motor is used on the Accentra-Cast, Advance, and the XXV pellet stoves that have the indirect chain drive feed system. This Gleason-Avery replacement motor is built to the same specification as the original.

Technical Bulletin Product Updates:

• Cooling Fan: There has been a design update removing the cooling fan from this motor. New motors will not come with it. Replacement fans for old motors are 3-20-08791
• Gearing: This motor has been designed to operate at a lower torque range for use with the updated chain-drive using a 1:1 sprocket ratio if your sprockets are different sizes, you need to update chain-drive system. We have an OEM complete motor mounting kit, 1-00-06626. We also have an aftermarket kit, 1-00-06626-AMP
• Accentra-Cast, Advance and XXV pellet stoves WITHOUT a chain drive system use an outboard 'direct-drive' motor that is mounted directly to the auger shaft without the chain system, part # 3-20-00667

UPC: 652174636716

Replacement For Part Number:

• 3-20-08752

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For Harman Feeder Motor For Advance, Accentra & Certain XXV (4RPM CCW): 3-20-08752

Instructional Documents

• Install Instructions PDF for Harman 3-20-08752

Instructional Notes

When securing the motor to this mounting bracket, Harman is nor recommending NOT TO USE the grommet and spacer. Instead, they want you to hard mount the motor to the bracket and forego the use of the grommets. Grommets and spacers must still be used on the original motor mounts that use the reduction gear, however; your stove will run much better if you update all of the parts to the new system, OEM complete motor mounting kit, 1-00-06626. We also have an aftermarket kit, 1-00-06626-AMP

Troubleshooting Notes

• The motor mount on your stove can become bent from the torque of the auger motor if your feed system becomes jammed. This will cause the chain to keep skipping off of the sprockets, even if the sprockets are replaced. This is most notable on motor mounts that did not have the base support weld.
• If your mount is bent, there is a good chance that the gears in your auger motor are also damaged. It is suggested to replace the auger motor 3-20-08752 whenever this bracket is replaced.

This Item Qualifies For Free Shipping!