Blaze King Wood Stove Glass (15-13/16" x 9-7/8"): S.Z0246-AMP

Blaze King Wood Stove Glass (15-13/16" x 9-7/8"). Made To Fit Newer PI, PE & RGT Models. It is important to periodically inspect the glass and glass gasket on your wood stove to ensure you have a proper seal. A crack in the glass or a missing / deteriorated gasket could allow smoke or flue gases to enter the room.    

Glass measurements are 15-3/16" x 9-7/8".

*Check your dimensions carefully prior to ordering. *

A Note About Our Glass: Unlike some manufacturers, we do not use tempered glass. Tempered glass should NEVER be used in a wood fuel stove, it is not suitable for high heat use. Our glass is made to resist very high temperatures up to 1,400° F / 760° C with low thermal expansion.

Replacement For Part Numbers:

• S.Z0246
• 0246

• Install Instructions PDF for Blaze King S.Z0246

DOOR GLASS / DOOR GLASS GASKET REPLACEMENT: 

1. Start by removing the door from the stove.

2. Place the door face down on a soft, flat, and even surface.

3. Loosen all bolts/fasteners that are securing the retainer clips to the door. It is a good idea to spray these fasteners with a product like WD40 or PB Blaster before this step. Doing so will greatly reduce the possibility of stripping or breaking any screws/bolts during removal.

4. Remove the old glass and place it on a soft, flat, and even surface.

5. Remove the old gasket from the glass.

6. Starting at one corner carefully wrap the gasket around the edges, pressing firmly onto the sides of the glass with the gasket centered on the edge. Finish the wrapping with a 1/2” overlap. Ensure the thickness of the gasket remains consistent and uniform. 

7. Set the glass into the door frame (Ensure the glass is parallel to the frame).

8. Install the glass retainers with original fasteners. Tighten the fasteners in a crisscross pattern. This will help to ensure there is even pressure on the glass (Do not overtighten).

Helpful Tips:

If you need to remove the glass or glass gasket it is a good idea to spray any fasteners with a product like WD40 or PB Blaster prior to this step. This will greatly reduce the possibility of stripping or breaking any screws / bolts during removal. When reinstalling the glass tighten the fasteners in a crisscross pattern. This will help to ensure there is even pressure on the glass (Do not overtighten).  

Please open and inspect your glass to make sure that it has arrived intact. Damage Claims for broken glass from shipping MUST be made within 72 hrs of delivery, no exceptions. Glass breaking from after installation is NOT covered under warranty, this is due to improper installation. If you do not feel comfortable replacing your glass, please contact a licensed technician. For instructions on proper glass installation, please read the instructions provided in the instructions tab.

This Item Qualifies For Free Shipping!