Skip to main content
Skip to main content
Product title:

Breckwell Pellet Stove Exhaust Blower Motor: A-E-027-AMP

Product rating:
Product price:
$149.99

A $150.00 Savings over the OEM

Product SKU ! PP7610
Product MPN ! A-E-027
Product availability: In Stock
Bullet point features
"It was easy to install and works great. I also noticed that it's a lot quieter than the one I had whose bearings were apparently going and gettin a little roudy! Good Price, fast delivery. "-Mame M.

Frequently Bought Together

Description

Breckwell Pellet Stove Exhaust Blower Motor by Fasco.  The exhaust blower is responsible for drawing smoke out of the unit and pulling combustion air into the stove.  It is important that the blower functions properly.  If the blower is not running as it should, smoke/flue gas may enter the room.  You may also notice a lazy flame and a poor burn as a result of inadequate combustion air being delivered to the fire. 

    Install Note: This blower comes wired with one male and one female wire lead. If you require two female leads, convert the male lead with the female to female connector. If you require two male leads, convert the female lead with the male to male connector.

       


      Replacement For Part Numbers:

      • A-E-027
      • 80641

      View Compatible Models

      UPC: 012685000985

      Compatible Models

        Breckwell

      • P1000 Big E
      • P2000 Tahoe
      • P22 Maverick
      • P22I Maverick Insert
      • P23 Sonora
      • P23I Sonora Insert
      • P24 Blazer
      • P24I Blazer Insert
      • P26 Cadet
      • P2700 Mojave
      • P32i Cadet
      • P4000 Classic Cast
      • P7000 Solstice

      Technical Specs

      Volts 115
      Cycles 60Hz
      Amps 1.6
      RPM 3000

      Instructions

      Install Instructions For Breckwell Pellet Stove Exhaust Blower Motor: A-E-027-AMP

      To replace the exhaust blower:


      1. Unplug the unit
      2. Open the service panel
      3. Locate the exhaust blower. If your unit has the original OEM blower, you may have to remove the entire blower assembly if the motor cannot be removed from the hub. This will also involve removing the vent from the end of the assembly. If you have a Breckwell Insert, you will need to remove the entire off-set assembly from the of blower assembly and attach it to the new assembly if you have a hub-less motor.
      4. Disconnect wiring
      5. Replace blower assembly along with any gaskets that were disturbed (included).
      6. Reconnect venting if it was disconnected
      7. Reattach the wiring
      8. NOTE: if the venting was removed, make sure to apply RTV silicone to the venting adapter and secure with a single self tapping screw.

      Troubleshooting