ComfortBilt Cast Burn Pot: BPCast1-AMP

ComfortBilt Cast Pellet Stove Burn Pot. When installing the burn pot make sure the ignitor port hole is towards the back of the stove. It is also important to make sure the pot sits flush on the cradle. A gap between the burn pot and cradle can alter airflow through the unit. This can cause issues with startup and cause an inefficient burn.

Multiple Sizes: This is the large version of the burn pot. There is also the stainless steel version CB-BP-SS-Large, these parts are interchangeable. Please double check your current burnpot carefully and compare dimensions, there were several sizes made.

Replacement For Part Numbers:

• BPCast1
• BP-1C

These are all of the confirmed compatible units for this product. Where To Find Your Make & Model

Check these against the part you are replacing before ordering. If a dimension does not match, contact us and we will confirm the fit.

Install Instructions For ComfortBilt Cast Burn Pot: BPCast1-AMP

Instructional Documents

• Install Instructions PDF for ComfortBilt BPCast1

Instructional Notes

Installation:

1.) Position the burn pot so the ignitor port hole is facing towards the rear of the stove.

2.) Make sure the top edge of the cradle (The area that will accept the burn pot) is free of any ash or debris.

3.) Set the burn pot into the cradle. Make sure the front of the pot clears the front catch and sits flush on top of the cradle (A gap between the burn pot and the cradle can alter airflow through the unit. Which can cause the stove to burn inefficiently and create start-up issues).

Click on Videos for more information!

Troubleshooting Notes

Cleaning:

It is important to make sure that you are getting proper airflow through the burn pot at all times. Inadequate airflow can cause ignition and burn issues. You should regularly clean the holes in the burn pot to ensure they are free of any ash/carbon build-up.

The frequency of this cleaning will vary based on how often you burn the stove, the quality of your fuel, and your vent configuration.

1.) To clean the burn pot, you can start by removing it from the cradle (Make sure that the stove is cool and there are no embers in the pot prior to this step!)

2.) Vacuum or brush out any visible ash or carbon deposits from inside the pot.

3.) Using a small brush, drill bit or Allen wrench systematically clear out each hole in the burn pot.

4.) Vacuum out the cradle area where the burn pot will sit prior to reinstalling the pot.

5.) Place the burn pot into the cradle. Make sure that it is sitting flush and there is no gap between the pot and cradle.

Click on Videos for more information!

This Item Qualifies For Free Shipping!