Whitfield Advantage II-T Pellet Stove Repair and Replacement Parts

 Part # 12055902 is the control board for Whitfield pellet stoves made prior to 1999 that did not have auto-ignition. This controller will also wor...

Replacement igniter cartridge for Whitfield and Lennox pellet stoves.A new igniter cartridge for Lennox pellet stoves will make lighting your pell...

Replacement 6" Exhaust Motor Gasket.   **Motor side 4 7/8" ID 6" OD** Note: This will fit stove models that have the 5 3/4" quick change style hub...

Aftermarket Whitfield Advantage ll Firebrick. Better Quality than the OEM This is a Replacement Firebrick in the standard style and is a 3 piece br...

Whitfield 12046300 Auger Motor Advantage I (WP2) Advantage II (WP2) Advantage II-T (WP2) Advantage III (WP2) Advantage II-T Classic (WP2) Advantag...

Replacement Convection Blower for select Whitfield Pellet Stoves. This blower pushes the warm air out of the stove and into your room. Also known a...

Whitfield Exhaust Blower 12056010 This is an exhaust blower that works with Whitfield stoves. Works only with "quick change 6" style hub only. Fit...

Replacement Exhaust Blower Gasket for Most Lennox, Breckwell, Enviro, & More (see compatible).    Note: Housing side 4 7/8" ID

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Replacement OEM Upper Auger Bushing For All Whitfield Pellet Stoves and Lennox Montage Pellet Stove. Replaces Part Number 12051100. Genuine Replac...

Replacement igniter cartridge for select Whitfield and Lennox pellet stoves.A new igniter cartridge for Lennox pellet stoves will make lighting yo...

Whitfield Pellet Stove 1 RPM Auger Motor The Whitfield pellet stove auger motor feeds the stove pellets from the hopper into the burn pot. This aug...

Whitfield & Lennox Silicone Auger Endplate Gasket Square, 61050003. Fits all Whitfield Stoves.

This is a Door Gasket, 1/2" x 7'. It may fit a variety of stoves. Included in those is Whitfield Advantage ll, ll-T, III and Plus Part #61057100

Convection Room Air Blower Gasket Fits Whitfield and Breckwell Stoves. Replaces Lennox part# 61057203 & Breckwell Part# C-G-100

Whitfield Advantage Burnpot For Older Models, 12150700 Burn Grate/ Burn Pot/Firepot for older Whitfield pellet stoves with serials 7217- 43377. Fit...

Replacement combustion quick disconnect square gasket for select Whitfield and Lennox pellet stoves. This gasket goes between the venting applianc...

Whitfield Burnpot For Older Units Advantage II T3. 12051263 Size: 5-1/4 wide burn grate Stainless steel replacement for 10 bar Ultragrate The body...

Replacement Ash Door Gasket Kit for Whitfield Advantage WP2 pellet stoves. Measures 3/8" x 1/8" x 10' with a self adhesive back. Fits the followin...

Whitfield Pellet Stove Room Fan/ Convection Blower. Fits the following stoves: All Advantage stoves, Profile 20/30, Optima 2/3, Quest Plus, T300P/T...

This gasket is self adhesive. It will fit with the following stoves: Traditions T300P Series and Whitfield Advantage Plus (WP7) both freestanding a...

Housing Side 4 7/8 inch ID - For use between blower housing and exhaust duct.Whitfield: Advantage Plus Insert, Advantage Plus FS, Advantage I, Adva...

Low Limit Proof of Fire Switch Replaces Whitfield Part #12057601, Lennox Part #H5887. Used on all Lennox pellet stoves and all Pre-Lennox Whitfiel...

Whitfield Advantage/Quest Pressure Switch Kit The Pellet Stove Pressure Switch Kit, by Lennox # 12145903. The stove vacuum switch indicates to the ...

The ceramic fiber, brick appearance insulating panel on the back wall of the firebox for Whitfield Advantage. Part #12146500

Replacement fuse for select Whitfield and Lennox igniters and control boards. It also works on the Montage stove and many others.Fuse replacement ...

Replacement pressure switch for select Whitfield and Lennox pellet stoves. This pressure switch exhibits a normally closed circuit, opening when t...

This appliance collar mount, also known as the tailpipe, will fit with most manufacturer exhaust blowers. Please check the dimensions of the one yo...

This is a centrifugal blower wheel impeller. 3.75"Convection replacement for plastic models.Fits the following Convection Blowers: PP7300 & Le...

After Market gasket 1 "O" ring, for Whitfield stoves. Replacement for part# 61057206

Replacement auger collar and set screw for select Whitfield and Lennox pellet stoves.

Replacement Whitfield combustion/exhaust blower kit. Includes combustion blower with housing #12056010, housing gasket #61057210, low limit switch ...

Replacement power cord with molded end for select Whitfield and Lennox pellet stoves.

Curved replacement glass (1piece) for Whitfield Advantage Plus (WP7) and Advantage III (WP3) models. This is the glass with glass gasket only. Adva...

Replacement Auger Motor for all Whitfield Pellet Stoves. Please note: this 1 RPM motor fits Quest (WP4) stoves with Oval Hole in Fireback; if your ...

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

Exhaust / Combustion blower for certain Whitfield stoves (Does not come with snap switch) #12056010Fits all Advantage stoves

Whitfield Firebrick Advantage I & II, 3 piece, 13-7/8" tall. Please confirm  that center brick height is 13-7/8" and that it matches the seri...

Whitfield Ultragate II Ten Bar Burn Pot ****NOTE**** Measure your burn grate before ordering. For older Whitfield - Advantage II Advantage ll-T ...

This ceramic exhaust low-limit heat sensor replaces part number 12057601.

Replacement pressure switch for select Whitfield and Lennox pellet stoves. This pressure switch exhibits a normally closed circuit, opening when t...

This is a Combustion Blower Impeller that fits Whitfield. 4.75" - 12 petal. Fits the following Whitfield stoves: Advantage- All models Legend Quest

This is a Firebrick. 3 piece brick kit. Herringbone Style. It fits the Whitfield: Advantage ll Advantage ll-T Advantage lll serial number 18145 and...

Replacement decorative ceramic log set for Whitfield WP2 Advantage Pellet Stoves. Fits 2-T, III, 2TC Replaces part numbers 12150001 & 12150002

This is a burn pot adaptor plate. You will use this adaptor to convert the 14 bar, 6 7/8" wide Burn Pot to the 5 1/4" wide burn pot. Fits the follo...

Convection & Exhaust Blower Modular Amp style, 2 wire plug in electrical connecter 25" long. Fits Older Whitfield Stoves with wiring terminal...