Whitfield Advantage I Pellet Stove Repair and Replacement Parts

Replacement 6" Exhaust Motor Gasket.   **Motor side 4 7/8" ID 6" OD** Note: This will fit stove models that have the 5 3/4" quick change style hub...

Whitfield 12046300 Auger Motor Advantage I (WP2) Advantage II (WP2) Advantage II-T (WP2) Advantage III (WP2) Advantage II-T Classic (WP2) Advantag...

Replacement Convection Blower for select Whitfield Pellet Stoves. This blower pushes the warm air out of the stove and into your room. Also known a...

Replacement Exhaust Blower Gasket for Most Lennox, Breckwell, Enviro, & More (see compatible).    Note: Housing side 4 7/8" ID

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Replacement OEM Upper Auger Bushing For All Whitfield Pellet Stoves and Lennox Montage Pellet Stove. Replaces Part Number 12051100. Genuine Replac...

Whitfield Pellet Stove 1 RPM Auger Motor The Whitfield pellet stove auger motor feeds the stove pellets from the hopper into the burn pot. This aug...

Whitfield & Lennox Silicone Auger Endplate Gasket Square, 61050003. Fits all Whitfield Stoves.

Convection Room Air Blower Gasket Fits Whitfield and Breckwell Stoves. Replaces Lennox part# 61057203 & Breckwell Part# C-G-100

Replacement combustion quick disconnect square gasket for select Whitfield and Lennox pellet stoves. This gasket goes between the venting applianc...

Replacement nylon lower auger bushing bearing for select Whitfield and Lennox brand pellet stoves.

Replacement Ash Door Gasket Kit for Whitfield Advantage WP2 pellet stoves. Measures 3/8" x 1/8" x 10' with a self adhesive back. Fits the followin...

This gasket will fit with the following Whitfield stove models: Optima (ALL) Profile 20 FS, Profile 30 FS, Profile 30 Insert, Advantage I,

This gasket is self adhesive. It will fit with the following stoves: Traditions T300P Series and Whitfield Advantage Plus (WP7) both freestanding a...

Whitfield Baffle Heat Deflector This is a Baffle Heat Deflector.********It replaces part # 13650046 Works with the following Whitfield Stoves: Adv...

Low Limit Proof of Fire Switch Replaces Whitfield Part #12057601, Lennox Part #H5887. Used on all Lennox pellet stoves and all Pre-Lennox Whitfiel...

Housing Side 4 7/8 inch ID - For use between blower housing and exhaust duct.Whitfield: Advantage Plus Insert, Advantage Plus FS, Advantage I, Adva...

Whitfield Advantage/Quest Pressure Switch Kit The Pellet Stove Pressure Switch Kit, by Lennox # 12145903. The stove vacuum switch indicates to the ...

This appliance collar mount, also known as the tailpipe, will fit with most manufacturer exhaust blowers. Please check the dimensions of the one yo...

After Market gasket 1 "O" ring, for Whitfield stoves. Replacement for part# 61057206

Replacement Auger Motor for all Whitfield Pellet Stoves. Please note: this 1 RPM motor fits Quest (WP4) stoves with Oval Hole in Fireback; if your ...

Replacement auger collar and set screw for select Whitfield and Lennox pellet stoves.

Replacement Whitfield combustion/exhaust blower kit. Includes combustion blower with housing #12056010, housing gasket #61057210, low limit switch ...

Replacement power cord with molded end for select Whitfield and Lennox pellet stoves.

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

Exhaust / Combustion blower for certain Whitfield stoves (Does not come with snap switch) #12056010Fits all Advantage stoves

Whitfield Firebrick Advantage I & II, 3 piece, 13-7/8" tall. Please confirm  that center brick height is 13-7/8" and that it matches the seri...

This ceramic exhaust low-limit heat sensor replaces part number 12057601.

Replacement low limit proof of fire snap switch for select Whitfield and Lennox pellet stoves. This switch controls the stove out of "STARTUP" mod...

This is a Combustion Blower Impeller that fits Whitfield. 4.75" - 12 petal. Fits the following Whitfield stoves: Advantage- All models Legend Quest

Convection & Exhaust Blower Modular Amp style, 2 wire plug in electrical connecter 25" long. Fits Older Whitfield Stoves with wiring terminal...

This is a replacement glass for Whitfield Advantage I, II, II-T Stoves. The measurements are 9" x 4 3/8" . Our replacement glasses are made with p...

Lower Auger Bearing. Replacement bearing for all Nylatron style lower auger end plates. Replacement for Lennox part number 12021101. This part does...

This is a replacement glass for Whitfield Advantage I, II, II-T Stoves. The measurements are 13" x 9" . Our replacement glasses are made with pyro...

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

Make routine maintenance a breeze with this complete pellet stove service kit. This kit includes everything you need to clean both your stove and ...

These are after market brick retainer clips. They fit with the Whitfield Firebricks Replaces part# 13640028 Works with the following Whitfield Stov...

Whitfield Center Glass With Gasket For The Advantage I/ II/ 2T & 2TC #12146400 13" X 9"

Brick Retainer Clips. They fit with the Whitfield Firebricks Replaces part# 11750011 Works with the following Whitfield Stoves: Advantage Plus Prof...

Replacement 4" quick disconnect kit for Lennox pellet stoves. This kit makes it easier to disconnect the pellet stove from the exhaust system. Inc...

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...