Whitfield Quest INS WP4 Pellet Insert Repair and Replacement Parts

Replacement pre-assembled exhaust combustion blower motor, fan blade, and gasket for select Whitfield pellet stoves. Does not include housing. This...

Whitfield 12046300 Auger Motor Advantage I (WP2) Advantage II (WP2) Advantage II-T (WP2) Advantage III (WP2) Advantage II-T Classic (WP2) Advantag...

Replacement OEM Upper Auger Bushing For All Whitfield Pellet Stoves and Lennox Montage Pellet Stove. Genuine Replacement Part. Made From Specially...

This is a Door Gasket, 1/2" x 7'. It may fit a variety of stoves. Included in those is Whitfield Advantage ll, ll-T, III and Plus Part #61057100

Whitfield & Lennox Silicone Auger Endplate Gasket Square, 61050003. Fits all Whitfield Stoves.

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Whitfield Pellet Stove 1 RPM Auger Motor The Whitfield pellet stove auger motor feeds the stove pellets from the hopper into the burn pot. This aug...

1 RPM, Clock-wise, "High-Torque" Replacement Auger Motor for all Whitfield, Traditions, Lennox/Whitfield, and IHP Pellet Stoves. NOTE: ALL WHITFIEL...

Whitfield Burnpot For Older Units Advantage II T3 Size: 5-1/4 wide burn grate Stainless steel replacement for 10 bar Ultragrate The body of this g...

Replacement combustion quick disconnect square gasket for select Whitfield and Lennox pellet stoves. This gasket goes between the venting appliance...

Low Limit Proof of Fire Switch Used on all Lennox pellet stoves and all Pre-Lennox Whitfield stove models. This switch controls the stove out of th...

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

Whitfield Baffle Heat Deflector Works with the following Whitfield Stoves: Advantage I Profile 20 Optima 2 Quest Plus Quest  

Quest Pellet Stove Control Board, by Lennox 13645900 Note: This board fits the Quest line, it does NOT fit the Quest Plus models

Housing Side 4 7/8 inch ID - For use between blower housing and exhaust duct.Whitfield: Advantage Plus Insert, Advantage Plus FS, Advantage I, Adva...

2-Speed Convection Blower for Whitfield Quest Freestanding &  Whitfield Quest Insert. Easy installation plug and play.  Formerly Part #PP7302

Replacement auger collar and set screw for select Whitfield and Lennox pellet stoves.

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

Replacement power cord with molded end for select Whitfield and Lennox pellet stoves.

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

This is a replacement Firebrick. It is in the standard style. This is a 1 piece firebrick. Fits Whitfield Quest Panel Height: 15 inches Panel Width...

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

Replacement low limit proof of fire snap switch for select Whitfield and Lennox pellet stoves. This switch controls the stove out of "STARTUP" mod...

7" Silicone Rubber Round Gasket Combustion Motor To Housing Circular shaped gasket. Combustion Blower Motor Gasket. Fits on Exhaust (Combustion) Bl...

This is a Combustion Blower Impeller that fits Whitfield. 4.75" - 12 petal. Fits the following Whitfield stoves: Advantage- All models Legend Quest

Cleanup the ashes from your stove is a breeze with the new AV15E ash vacuum from US Stove Company. With a 2.5 peak horse power motor and a 6.5 Gall...

Whitfield Ultragate II Ten Bar Burn Pot ****NOTE**** Measure your burn grate before ordering. For older Whitfield - Advantage II Advantage ll-T ...

Convection & Exhaust Blower Modular Amp style, 2 wire plug in electrical connecter 25" long. Fits Older Whitfield Stoves with wiring terminal...

Whitfield Quest Pellet Stove Firebrick. Herringbone style Fits Whitfield Quest Replaces Lennox part # 13646500  Panel Height: 6 3/8 inches Panel...

This is a replacement wiring adapter with a Male Crimped Terminal Spade to a Female Spade Terminal. Can be used on blowers, auger motors, and more....

Whitfield Burnpot For Older Units Advantage II T3 Size: 5-1/4 wide burn grate Stainless steel replacement for 10 bar Ultragrate The body of this g...

Wire connector with 2 male spades and a Molex style connector.

Pressure Switch Kit # 13640014 This part is compatible for: Quest Plus FS (WP4) Quest Insert (WP4) Advantage II Pellet Stove Freestanding & Ins...

The Quest has an oval feed chute in the back wall whereas the Quest Plus has a rectangular feed chute.Quest Insert-WP4Quest FS-WP4

Make routine maintenance a breeze with this complete pellet stove service kit. This kit includes everything you need to clean both your stove and ...

These are after market brick retainer clips. They fit with the Whitfield Firebricks Replaces part# 13640028

4-in-1 Multi-Purpose Wire Service Tool. Cutter, Stripper, Crimper, & Gripper. 7in total overall length.

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

Replacement heat exchange baffle for models Profile 20, Quest plus WP4, Quest & Optima 2

Replacement auger shaft for select Whitfield and Lennox pellet stoves.

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

Replacement auger shaft for select Whitfield and Lennox pellet stoves.

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

Pressure Switch Kit # 13640014 This part is compatible for: Quest Plus FS (WP4) Quest Insert (WP4) Advantage II Pellet Stove Freestanding & Ins...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...