Whitfield Profile 30 INS Pellet Insert Repair and Replacement Parts

Replacement Convection Blower for select Whitfield Pellet Stoves. This blower pushes the warm air out of the stove and into your room. Also known a...

Whitfield 12046300 Auger Motor Advantage I (WP2) Advantage II (WP2) Advantage II-T (WP2) Advantage III (WP2) Advantage II-T Classic (WP2) Advantag...

This is a "quick change", motor ONLY, exhaust blower for Whitfield stoves and does not come with housing assembly, low limit switch or appliance co...

Replacement nylon lower auger bushing bearing for select Whitfield and Lennox brand pellet stoves.

Whitfield & Lennox Silicone Auger Endplate Gasket Square, 61050003. Fits all Whitfield Stoves.

Whitfield Control Board Replacement Control Board for Whitfield Profile 30 & Optima 3. 120V AC. LED display. We carry a wide selection of Whitf...

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Whitfield Pellet Stove 1 RPM Auger Motor The Whitfield pellet stove auger motor feeds the stove pellets from the hopper into the burn pot. This aug...

1 RPM, Clock-wise, "High-Torque" Replacement Auger Motor for all Whitfield, Traditions, Lennox/Whitfield, and IHP Pellet Stoves. NOTE: ALL WHITFIEL...

Whitfield Burnpot For Older Units Advantage II T3 Size: 5-1/4 wide burn grate Stainless steel replacement for 10 bar Ultragrate The body of this g...

Replacement combustion quick disconnect square gasket for select Whitfield and Lennox pellet stoves. This gasket goes between the venting appliance...

Replacement exhaust blower motor 7" gasket for select Whitfield and Lennox pellet stoves. This gasket should be replaced as needed when removing t...

This gasket will fit with the following Whitfield stove models: Optima (ALL) Profile 20 FS, Profile 30 FS, Profile 30 Insert, Advantage I,

Low Limit Proof of Fire Switch Used on all Lennox pellet stoves and all Pre-Lennox Whitfield stove models. This switch controls the stove out of th...

Replacement ceramic fiber brick panel set with standard pattern that goes on the back and side walls of the firebox. Center Panel Height: 7 1/2 in...

Whitfield Pellet Stove Door Rope Gasket 7' x 1" (for 3 Piece Glass doors) For Whitfield: Optima Profile 30 Insert Profile 30.

Replacement fuse for select Whitfield and Lennox igniters and control boards. It also works on the Montage stove and many others.Fuse replacement ...

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

proof of flame sensor. This replacement includes a mounting bracket. Replacement for part# 12055908 FIts the following Whitfield Stoves: Advantage...

Whitfield Pellet Stove Room Fan/ Convection Blower. Fits the following stoves: All Advantage stoves, Profile 20/30, Optima 2/3, Quest Plus, T300P/T...

Replacement auger collar and set screw for select Whitfield and Lennox pellet stoves.

This 8-foot gasket is for models with 1 Piece Bent Glass not the unit with 3 pieces of glass on door.Optima, Profile 20, Profile 30, Traditions T30...

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

This is a centrifugal blower wheel impeller. 3.75"Convection replacement for plastic models.Fits the following Convection Blowers: PP7300 & Le...

Replacement power cord with molded end for select Whitfield and Lennox pellet stoves.

Replacement pressure switch for select Whitfield and Lennox pellet stoves. This pressure switch exhibits a normally closed circuit, opening when t...

This Combustion blower comes with POF snap(12057601) switch and housing to stove mounting gasket (61050005). The Combustion blower is also known as...

Replacement high limit heat sensor for select Whitfield and Lennox pellet stoves. This snap switch is an important safety device, monitoring your ...

Replacement pressure switch for select Whitfield and Lennox pellet stoves. This pressure switch exhibits a normally closed circuit, opening when th...

Curved replacement glass (1piece) for Whitfield Advantage Plus (WP7) and Advantage III (WP3) models. This is the glass with glass gasket only. Adva...

Replacement convection blower gasket for select Whitfield and Lennox pellet stoves.

This is a replacement wiring adapter for switching a male spade connector into a female spade connector. Can be used on blowers, auger motors, and ...

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

7" Silicone Rubber Round Gasket Combustion Motor To Housing Circular shaped gasket. Combustion Blower Motor Gasket. Fits on Exhaust (Combustion) Bl...

Whitfield Auger End Plate for Profile 30FS & Insert #17250241  

Replacement Convection Blower for compatible Whitfield Stoves. The Convection Blower pulls the rooms cool air across the burn pot. Making the fire ...

Cleanup the ashes from your stove is a breeze with the new AV15E ash vacuum from US Stove Company. With a 2.5 peak horse power motor and a 6.5 Gall...

Whitfield Ultragate II Ten Bar Burn Pot ****NOTE**** Measure your burn grate before ordering. For older Whitfield - Advantage II Advantage ll-T ...

Replacement Cleaning Brush for Whitfield and Lennox pellet stoves.

Lower Auger Bearing. Replacement bearing for all Nylatron style lower auger end plates. This part does NOT fit the old brass bearing end plate. If ...

This is a replacement wiring adapter with a Male Crimped Terminal Spade to a Female Spade Terminal. Can be used on blowers, auger motors, and more....

This 5 Amp Fuse Fits The Following Stoves: Profile 20 Profile 30 Profile 30 Insert Traditions T300 This is the fuse that is located INSIDE of the...

Replacement ceramic fiber brick panel set with herringbone pattern that goes on the back and side walls of the firebox. Center Panel Height: 7 1/2...

Whitfield Burnpot For Older Units Advantage II T3 Size: 5-1/4 wide burn grate Stainless steel replacement for 10 bar Ultragrate The body of this g...

Wire connector with 2 male spades and a Molex style connector.

When the cell detects light from the fire (fire dominance scheme), a 2.4-volt signal is created by the photocell which closes the solenoid in the p...

This Auger End Plate Fits multiple models: see compatible  Part Number: 17250241