Quadra-Fire Mt Vernon Pellet Stove Repair and Replacement Parts

This is the factory shipped, original equipment, 380-watt replacement igniter for most Quadrafire pellet stoves and inserts made from 2006 forward....

This is the factory shipped, original equipment, 380-watt replacement igniter for most Quadrafire pellet stoves and inserts made from 2006 forward....

Thermocouple Cover. This 3" long cover is the updated replacement part for the longer version that was used in the past.

Replacement tadpole door gasket for Quadra-Fire pellet and gas stoves. The gasket measures about 1" wide x 3/8" thick and comes in a 10' length, wh...

This QuadraFire 14" thermocouple is a replacement part for the Castile, Santa Fe, Countour, and the Mt Vernon original model. The thermocouple is m...

The vacuum switch is located inside the mechanical area of the appliance and will have a black or reddish-orange hose attached. This switch closes ...

QuadraFire 2.4 RPM feed motor for most pellet stoves and inserts. This part is commonly called an auger motor. Includes the motor, mounting bracket...

Quadra-Fire Exhaust Combustion Blower, Motor Only Replacement. This part ONLY fits the original Mt Vernon Stove model which was discontinued in 200...

  Quadrafire's Snap disc #3 is always mounted on the backside of the feed tube, directly in line with the opening of the drop chute. To access this...

Replacement 7 AMP Fuse for Quadra-Fire pellet stoves. This is the fuse used in the junction box on most models.

Quadra-Fire Pellet Stove Vacuum Switch This pellet stove replacement part includes both hoses and the Vacuum Pressure Switch. If the switch senses ...

Thermocouple Cover. This 3" long cover is the updated replacement part for the longer version that was used in the past.

Replacement Quadrafire firepot gasket. This gasket seals the edge under the firepot where it mounts into the stove. Compatible with the SRV414-5200...

This QuadraFire 14" thermocouple is a replacement part for the Castile, Santa Fe, Countour, and the Mt Vernon original model. The thermocouple is m...

Quadrafire Replacement Low Limit Snap Disc #1 110 Degree F Convection Blower On/Off Control for Quadrafire small Pellet stoves.  Replace this part ...

SRV230-1960 Snap Disc #2 is an older style safety switch used on the Mt Vernon and Contour Series until they were discontinued.  Castile FS - Pre ...

This 8 foot black, shielded power cord features a C13 (female) connector on one end and a NEMA 5-15P (male) connector on the other end. The cable i...

 Quadrafire's Snap disc #3 is always mounted on the backside of the feed tube, directly in line with the opening of the drop chute. To access this ...

This pellet stove replacement Convection Bower for the Mt Vernon, which is the original model made between 2002-06 (Pre AE). The original part numb...

Quadrafire Mt Vernon OM (Original Model) - Snap Disc #2 (Feed System Override) L175°F Manual Reset Snap disc #2 is located on the right side of the...

QuadraFire 2.4 RPM feed motor for most pellet stoves and inserts. This part is commonly called an auger motor. Includes the motor, mounting bracket...

The vacuum switch is located inside the mechanical area of the appliance and will have a black or reddish-orange hose attached. This switch closes ...

Replacement nylon auger bearing for many models.Compatible with the following Quadrafire pellet stoves: Mt Vernon, Mt Vernon AE, Mt Vernon AE Inser...

This Quadra-Fire combustion blower motor gasket is used on the original model (OM) Mt Vernon pellet stove, (Pre AE 2006). This gasket mounts betwee...

Quadra-Fire Exhaust Combustion Blower Motor, complete with housing. This part ONLY fits the original Mt Vernon Stove model which was discontinued i...

This pellet stove replacement Convection Bower for the Mt Vernon, which is the original model made between 2002-06 (Pre AE). The original part numb...

Replacement 4-speed control box/board for Quadra-Fire pellet stoves. Includes the control box, wire, and instructions. Fits the following Quadra-Fi...

SRV230-1960 Snap Disc #2 is an older style safety switch used on the Mt Vernon and Contour Series until they were discontinued and was also used on...

Replacement Feed Motor Gasket for the CB1200, Castile, and Santa-Fe Series of pellet stoves and inserts. Also, used for the original Mt Vernon pell...

Mechanical thermostat for Quadrafire Pellet and Gas Stoves.

QuadraFire 2.4 RPM feed motor for most pellet stoves and inserts. This part is commonly called an auger motor. Includes ONLY the motor and the capa...

Snap Disc #1 (Convection Blower) F125°-20 Snap disc #1 is located on the right side of the appliance on the top of the heat exchanger box. There ar...

This is a 1/4" female spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical component...

This is a 7-Day Programmable Thermostat for Quadrafire Pellet and Gas Stoves. This TSTAT requires 2 AA batteries, which are included. This TSTAT i...

This is a 1/4" male spade, fully Insulated "Quick-Disconnect" terminal for 22-18 wire gauge that is used to connect power to electrical components ...

Replacement 1-1/4" firepot bolt for Quadra-Fire pellet stoves.

Replacement ceramic wire nut for Quadrafire pellet stoves, used for connecting the igniter wires.

Make routine maintenance a breeze with this complete pellet stove service kit. This kit includes everything you need to clean both your stove and ...

Replacement auger/feed spring assembly for Quadra-Fire pellet stoves and inserts. Includes the set screw and a gasket, (not pictured). Compatible w...

Snap Disc #1 (Convection Blower) F125°-20 Snap disc #1 is located on the right side of the appliance on the top of the heat exchanger box. There ar...

Replacement Vac Hose for the Vac Switch. Used on the Quadrafire, 30" X 3/16 ID

This is the 12 petal impeller fan blade for the combustion exhaust blower motor that is used on the original Mt Vernon Pellet Stove that was made b...

Replacement hopper lid rubber bumper fits many Quadrafire pellet stoves.

Control Board for Quadrafire Mt Vernon E2 Freestanding and Insert  Part #SRV7080-050

This is a replacement wiring adapter for switching a female spade connector into a male spade connector. Can be used on blowers, auger motors and m...

Replacement 7/8" Feed Motor Set Collar for Quadrafire Pellet Stoves. Compatible with the following Quadrafire pellet stoves: Mt Vernon, Mt Vernon A...

Replacement 1/4-20 Lock Nut for Quadrafire pellet stove firepots.